12 February 2013 in Optics Express
Nanoantennas are key optical components for several applications including photodetection and biosensing. Here we present an array of metal nano-dipoles supporting surface plasmon polaritons (SPPs) integrated into a silicon-based Schottky-contact photodetector. Incident photons coupled to the array excite SPPs on the Au nanowires of the antennas which decay by creating ”hot” carriers in the metal. The hot carriers may then be injected over the potential barrier at the Au-Si interface resulting in a photocurrent. High responsivities of 100 mA/W and practical minimum detectable powers of −12 dBm should be achievable in the infra-red (1310 nm). The device was then investigated for use as a biosensor by computing its bulk and surface sensitivities. Sensitivities of ∼ 250 nm/RIU (bulk) and ∼ 8 nm/nm (surface) in water are predicted. We identify the mode propagating and resonating along the nanowires of the antennas, we apply a transmission line model to describe the performance of the antennas, and we extract two useful formulas to predict their bulk and surface sensitivities. We prove that the sensitivities of dipoles are much greater than those of similar monopoles and we show that this difference comes from the gap in dipole antennas where electric fields are strongly enhanced.
1 February 2021 in AIP Advances
The fabrication of a high-speed plasmonic reflection/transmission modulator for operation at λ0 = 1550 nm is presented and described in detail. Front-side ground and signal contacts provide easy electrical probe access to the device, while allowing the transmission of light through the substrate. Modulation is based on enhanced perturbation of the effective refractive index of grating-coupled surface plasmon polaritons propagating along a metal–oxide–semiconductor structure on silicon. Fabrication steps include deposition of a plasmonic metal patch, deposition of Ohmic contacts, deposition of an Au nanograting coupler overlaid by e-beam lithography, and the application of an intermetal dielectric layer with metalized vias and metal electrical contacts. Current–voltage and capacitance–voltage characteristics verify the electrical integrity of the structure.