This paper proposes an integrated method of three-phase ac excitation and high-frequency voltage signal injection (HFVSI) for sensorless controlled starting of brushless synchronous machines (BSM) used as starter/generator in variable frequency ac power systems of civil aircraft. Fixed 400 Hz of the three-phase ac power is adopted both for the ac excitation and HFVSI in the initial starting process to eliminate the bulky rotor position sensor for BSM. The resulting 6th sequence harmonic voltage determined by the rotating rectifier is utilized as the HFVSI into the field-winding of main generator without any extra high-frequency signal injection. The rotor position is estimated by the high-frequency response signals extracted from the armature windings of main generator. Due to the nonlinear rotating rectifier linked in the HFSI chain, a novel frequency-insensitive asynchronous demodulation strategy is proposed in this paper for rotor position estimation. Furthermore, the initial rotor position detection is calibrated by polarity decision of the induced currents of the armature windings within the establishment procedure of field current of the main generator at standstill. The effectiveness of the ac excitation and feasibility of rotor position estimation for sensorless starting control of BSM are validated by the simulation and experimental results.
1 July 2020 in IEEE Transactions on Industrial Electronics
This paper proposed a sensorless starting control method for the brushless synchronous machine(BSM) with the indirectly injected high-frequency signal, where the high-frequency signals are injected into the stator windings of the main exciter(ME) instead of the main generator(MG). The impact of the nonlinear links of the rotary rectifier and various filters on the rotor position estimation error during the asynchronous demodulation method is analyzed in detail. Since the phase delay of the band-pass filter(BPF) and the low-pass filter(LPF) will deteriorate the zero-crossing points of the envelope curve, the signal restoration module could not restore the sinusoidal envelope curve accurately, then, the estimated rotor position error is expanded with the increasing of rotor speed in the starting process. Therefore, a novel mathematical analysis method with fewer filters for the rotor position demodulation is presented to improve the estimated rotor position error compared to the traditional method, and the feasibility and effectiveness of the proposed method are verified by the comparison of the simulation and experimental results.
A novel chaotic model of electric arc furnace (EAF) is proposed in consideration of the chaotic nature of electric fluctuations caused by EAF. Based on the model proposed above, flexible power system of EAF is studied by using STATCOM in this paper. VO-DPC control method is adopted for STATCOM control due to its advantages like simple system structure, good dynamic performance, and high efficiency. Based on the data from a real EAF power supply system of a steel plant, the paper conducted simulation of this flexible power system. The simulation results show that this novel flexible power supply system can effectively damp voltage fluctuation and flicker, which hits the target of flexible power supply.
This paper analyzed the principle and performance characteristics of PR controller, and proposed a control strategy based on improved PR controller of direct-driven permanent magnet synchronous wind power generation system. Instead of the traditional PI controller, improved PR controller is used to saving a coordinate transformation, eliminating the cross-decoupling terms and feed-forward compensation items, and simplifying the control algorithm. The introduction of improved PR controllers has superior performance in permanent magnet synchronous motor control system, it can realize no static difference to the AC input signal. For validation, simulation model is built to experiments and analysis.