Mohammad Javad Emadi

Mohammad Javad Emadi

Auto-generated profile, based on publicly available information

Mohammad Javad Emadi

Department of Electrical Engineering, Amirkabir University of Technology (Polytechnic of Tehran), Tehran, Iran

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 November 2019 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Closed access
HMHamed Masoumi
Hamed Masoumi
MEMohammad Javad Emadi
Mohammad Javad Emadi
We study uplink of cell-free massive multiple-input multiple-output system with limited capacity fronthaul link connecting each access point (AP) to a central processing unit (CPU), under hardware impairments at user equipments and APs. Achievable rates are derived for three transmission strategies at APs, named as compress-forward-estimate (CFE), estimate-compress-forward (ECF), and estimate-multiply-compress-forward (EMCF), to efficiently share the fronthaul capacity for sending channel state information (CSI) and/or data signals of the users to the CPU. For forwarding the compressed version of the signals, low-complexity fronthaul rate allocations are proposed for ECF and EMCF strategies, which considerably improve the performance especially for limited capacity fronthauls. Besides, for CFE and ECF strategies, two power allocations are presented to maximize the sum rates; One approximate solution based on geometric programming and an alternative general iterative algorithm. It is shown that performances of the strategies are not the same, because they require different fronthaul rate allocations for CSI and/or data signals transmission to CPU, and their AP signal processing capabilities are different. Finally, to highlight performance characteristics of the proposed system under different transmission strategies and circumstances such as pilot reuse and multiple-antenna APs scenarios, numerical results are presented and the three strategies are compared.

2 April 2021 in IEEE Transactions on Cognitive Communications and Networking
Verified
Journal Article
Closed access
MSMohammad Amin Saeidi
Mohammad Amin Saeidi
MEMohammad Javad Emadi
Mohammad Javad Emadi
HMHamed Masoumi
Hamed Masoumi
MMMohammad Robat Mili
Mohammad Robat Mili
DNDerrick Wing Kwan Ng
Derrick Wing Kwan Ng
IKIoannis Krikidis
Ioannis Krikidis
Smart and reconfigurable wireless communication environments can be established by exploiting well-designed intelligent reflecting surfaces (IRSs) to shape the communication channels. In this paper, we investigate how multiple IRSs affect the performance of multi-user full-duplex communication systems under hardware impairment at each node, wherein the base station (BS) and the uplink users are subject to maximum transmission power constraints. Firstly, the uplink-downlink system weighted sum-rate (SWSR) is derived as a system performance metric. Then, we formulate the resource allocation design to maximize the SWSR as an optimization problem which jointly optimizes the beamforming and the combining vectors at the BS, the transmit powers of the uplink users, and the phase shifts of multiple IRSs. Since the SWSR optimization problem is non-convex, an efficient iterative alternating approach is proposed to obtain a suboptimal solution for the design problem. In particular, we first reformulate the main problem into an equivalent weighted minimum mean-square-error form and then transform it into several convex sub-problems which can be analytically solved for given phase shifts. Then, the IRSs phases are optimized via a gradient ascent-based algorithm. Finally, numerical results are presented to clarify how multiple IRSs enhance the performance metric under hardware impairment.

11 March 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
MMMahdieh Mehrabi
Mahdieh Mehrabi
HBHamzeh Beyranvand
Hamzeh Beyranvand
MEMohammad Javad Emadi
Mohammad Javad Emadi
Recently, multi-band elastic optical networks (MB-EONs) have been introduced to increase the transmission capacity of optical networks by expanding the transmission frequency range beyond the conventional C-band (e.g., O-, E-, S-, and L-band). Thus, by utilizing the idle frequency bands of the existing standard single mode fibers (SMFs), the capacity improvement in MB-EONs is achieved with lower capital expenditure compared to other techniques, such as space division multiplexing (SDM) in multi-core fibers (MCFs). The routing, modulation level and spectrum assignment (RMLSA) problem in MB-EONs is more challenging than that of the conventional single band EONs, and the inter-channel stimulated Raman scattering (ISRS) process should be considered in signal-to-noise ratio (SNR) analysis. In this article, ISRS-aware RMLSA problem in MB-EONs is studied. We obtain the optimal solution of this problem by formulating a path-based integer linear programming (ILP) model. Since the number of slots and demands are too large in a multi-band system, the ILP problem is too complex to be solved in polynomial time. Therefore, we propose heuristic algorithms to solve the ISRS-aware RMLSA problem. Then, performance of the proposed schemes is evaluated through exhaustive simulations. The results reveal that among all the proposed heuristic algorithms, the algorithm named as enhanced in-process estimation (EIPE) has the best performance in saving more frequency slots for future demands, while achieving higher spectral efficiency and SNR estimation accuracy. Moreover, for a special case of small-scale scenario, the performance of EIPE is close to the results of ILP formulation. Finally, our results indicate that by ignoring ISRS process in the SNR estimation, outage occurs for some of lightpaths, where the outage percentage depends on the launch power.

21 September 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
PAPouya Agheli
Pouya Agheli
HBHamzeh Beyranvand
Hamzeh Beyranvand
MEMohammad Javad Emadi
Mohammad Javad Emadi
Underwater sensor networks (UWSNs) are of interest to gather data from underwater sensor nodes (SNs) and deliver information to a terrestrial access point (AP) in the uplink transmission, and transfer data from the AP to the SNs in the downlink transmission. In this paper, we investigate a triple-hop UWSN in which autonomous underwater vehicle (AUV) and unmanned aerial vehicle (UAV) relays enable end-to-end communications between the SNs and the AP. It is assumed that the SN–AUV, AUV–UAV, and UAV–AP links are deployed by underwater optical communication (UWOC), free-space optic (FSO), and radio frequency (RF) technologies, respectively. Two scenarios are proposed for the FSO uplink and downlink transmissions between the AUV and the UAV, subject to water-to-air and air-to-water interface impacts; direct transmission scenario (DTS) and retro-reflection scenario (RRS). After providing the channel models and their statistics, the UWSN's outage probability and average bit error rate (BER) are computed. Besides, a tracking procedure is proposed to set up reliable and stable AUV– UAV FSO communications. Through numerical results, it is concluded that the RSS scheme outperforms the DTS one with about 200% (32%) and 80% (17%) better outage probability (average BER) in the uplink and downlink, respectively. It is also shown that the tracking procedure provides on average 480% and 170% improvements in the network's outage probability and average BER, respectively, compared to poorly aligned FSO conditions. The results are verified by applying Monte-Carlo simulations.

3 June 2021 in IEEE Transactions on Cognitive Communications and Networking
Verified
Journal Article
Open access
YKYasaman Khorsandmanesh
Yasaman Khorsandmanesh
MEMohammad Javad Emadi
Mohammad Javad Emadi
IKIoannis Krikidis
Ioannis Krikidis
Future of massive Internet-of-Things (IoT) and low latency applications hinges on delivering fresh information on time. Thus, to analyse data freshness for time critical use cases in future networks, the age of information (AoI) measure is introduced. Besides, energy harvesting is also essential to improve energy sustainability and lifetime of a power-constrained and cost-efficient network. Therefore, we investigate a new network architecture suitable for future massive IoT where connectivity, energy sustainability and freshness of information are emerged. We study a wireless powered cooperative network, wherein a source and a relay charge their finite-sized capacitors by harvesting energy from a power station. For decode-and-forward (DF) and amplify-and-forward relaying strategies, average AoI and peak AoI (PAoI) are investigated to indicate how the randomness of the data/power transfer and size of the capacitors affect the age metrics. It is shown that, although utilizing a power-limited relay imposes more delay, the age metrics could be improved. Specifically, for the DF scheme with more waiting time due to signal processing, we may achieve lower average PAoI due to improving the reliability. Furthermore, special cases of the proposed system are discussed, e.g., full-power nodes and one-shot successful data transmission. Finally, numerical results are provided to clarify when a relaying strategy can outperform the direct transmissions. It is shown that for all values of the size of the capacitors, position of the relay, the power station’s power, and etc, there is not a unique optimal transmission strategy to minimize AoI metrics.

9 October 2018 in IEEE Wireless Communications Letters
Verified
Journal Article
Closed access
MAMohsen Abedi
Mohsen Abedi
HMHamed Masoumi
Hamed Masoumi
MEMohammad Javad Emadi
Mohammad Javad Emadi
We study optimal power splitting-based simultaneous wireless information and power transfer (PS-SWIPT) for two communication systems wherein all receiving nodes are subject to a decoding cost. First, for a point-to-point (PtP) channel, the optimal achievable rate is obtained, and then, for a two-hop half-duplex (HD) decode-and-forward (DF) relay channel, the achievable data rate is maximized. Finally, performances of the PtP system and the relay channel with DF and amplify-and-forward (AF) relaying schemes are discussed where we observe performance superiority of the DF relay channel over AF relaying and the PtP channel for sufficiently less decoding cost at the relay than the destination.