One of the ways to reduce road accident is to identify the humps and potholes present in the path. In this paper, an internet of things based road monitoring system (IoT-RMS) is proposed to identify the potholes and humps in the road. The pathway which is affected by the pothole is greatly influenced by the scattering signal of the ultrasonic sensor. So the magnitude of the reflected signal decreased due to the roughness of the surface and the signal amplitude is difficult to analyze. The Kirchofft's theory basically applied for real-time analysis and it has certain limitations. To overcome this difficulty, an accelerometer has been included with the ultrasonic sensor to measure variation present in the signal and optimized using honey bee optimization (HBO) technique. The IoT-RMS automatically updates the status of the road with location information in the cloud. Each road vehicles can access the information from the server and estimate the speed according to the potholes and humps present on the road. The simulation has been done and the result shows that the IoT-RMS can be accommodated in road vehicles to reduce the accidents. The proposed system is implemented and tested using Arduino Uno with ESP 8266.
This paper describes an Internet of things (IoT) based track monitoring system for increasing the comfort of rail track transportation. Usually, rail tracks are inspected only at midnight and also the inspection is carried out only once in a month or lesser. Unfortunately, any emergency issues not detected within the stipulated time leads to train derailment and other safety concerns. Hence in-service vehicle has been introduced to increase the safety of train transportation. In this paper, track irregularities are detected using bogie and car body acceleration measurements and these measurements is further optimized using particle swarm optimization algorithm (PSO). The proposed system is compared with the conventional track geometry measurement system. The monitoring and control information can be sent through IoT. Simulation results are performed for two different speed scenarios and it shows that the proposed system produces better results than the traditional track geometry measurement system and the effectiveness of the proposed method.