The paper presents a method of calculation of position deviations from a theoretical, nominally rectilinear trajectory for a SAR imaging system installed on board of UAV. The UAV on-board system consists of a radar sensor, an antenna system, a SAR processor and a navigation system. The main task of the navigation part is to determine the vector of differences between the theoretical and the measured trajectories of UAV center of gravity. The paper includes chosen results of experiments obtained during ground and flight tests.
The paper presents a method of calculation of motion correction parameters for a Synthetic Aperture Radar (SAR) installed on an Unmanned Aerial Vehicle (UAV). The UAV on-board system consists of a Radar Sensor, an Antenna System, a SAR Processor and a Navigation System. The main task of the navigation part is to determine the vector of difference between a theoretical and a real trajectory of the UAV's center of gravity. The paper includes chosen results of experiments obtained during ground tests.
The article presents a navigation system used to improve the quality of terrain images obtained from a Synthetic Aperture Radar (SAR) installed on a miniature unmanned aerial vehicle. An inertial navigation system is used to determine the flight path deviations from an assumed straight line. Calculated position corrections are used to correct the phase of the received echo signal in order to get a focused SAR image. The paper describes chosen results of in-flight experiments, presenting the influence of navigation correction on SAR images.
The paper describes a Synthetic Aperture Radar system currently developed by the Military University of Technology and a Polish private company WB Electronics S.A. in a frame of a project under acronym WATSAR. The project is aimed at designing, development and testing of a terrain imaging radar system operating from a miniature UAV. The paper presents structure and way of operation of the system and its current state of development. The main focus of the paper is directed onto presentation of radar images obtained during two flight campaigns realized in May and July 2015. The paper addresses also the algorithms used for SAR processing and the adopted methodology of in-flight experiments.
The article describes a method of determining the boundaries of an area (called swath) scanned by a side-looking airborne radar. The method assumes that the boundaries of the area are associated with the effective (measured at a level of -3 dB) antenna beam width in the range direction. It takes into account the aircraft altitude above the ground level and its roll and yaw angles. The presented method was tested using measurements obtained from a synthetic aperture radar system.