The first experimental observation of a Korteweg–de Vries-type soliton wave train in intense electron beams is reported. A narrow, large-amplitude perturbation on a long-pulse beam is observed to steepen and spawn a soliton wave train. The pulse width and amplitude of each peak remain unchanged over a long propagation distance, and the amplitude is inversely proportional to the square of the width. Two such pulses are seen to pass through each other, emerging from the collision unchanged. The experimental results are reproduced by particle-in-cell simulations.
An induction cell has successfully been demonstrated to longitudinally confine a space-charge dominated bunch for over a thousand turns in the University of Maryland Electron Ring [Haber et al., Nucl. Instrum. Methods Phys. Res. A 606, 64 (2009) and R. A. Kishek et al., Int. J. Mod. Phys. A 22, 3838 (2007)]. With the use of synchronized periodic focusing fields, the beam is confined for multiple turns overcoming the longitudinal space-charge forces. Experimental results show that an optimum longitudinal match is obtained when the focusing frequency for containment of the 0.52 mA beam is applied at every fifth turn. Containment of the beam bunch is achievable at lower focusing frequencies, at the cost of a reduction in the transported charge from the lack of sufficient focusing. Containment is also obtainable, if the confinement fields overfocus the bunch, exciting multiple waves at the bunch ends, which propagate into the central region of the beam, distorting the overall constant current beam shape.
4 August 2017 in Journal of Electromagnetic Waves and Applications
A mobile heater for ionospheric modification studies requires a new megawatt (MW) class radio frequency (RF) source operating with an antenna array 1/20 the area of the High-Frequency Active Auroral Research Program (HAARP). To deliver an effective power density comparable to HAARP, the total source power must be in the range of 16 MW, thus demanding highly efficient sources. While the development of a whole multi-megawatt system for mobile ionospheric heaters is a complex engineering problem, in the present paper we describe only the work of our group on studying main features of a prototype MW-class vacuum electronics RF source for such system. The source design we are currently pursuing assumes class D operation using a modified version of the inductive output tube. The electron beam is a thin annular beam, switched on and off by a mod-anode as opposed to a grid. The beam is then passed through a decelerating gap, and its kinetic energy is extracted using a tunable resonant circuit that presents a constant impedance in the range of 3–10 MHz. With this design the beam is almost completely decelerated at all frequencies, thus achieving high efficiency.
1 January 2014 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
With ever increasing demands for intensities in modern accelerators, the understanding of space-charge effects becomes crucial. Herein are presented measurements of optically shaped picosecond-long electron beams in a superconducting L-band linac over a wide range of charges, from 0.2 nC to 3.4 nC. At low charges, the shape of the electron beam is preserved, while at higher charge densities, modulations on the beam convert to energy modulations. Energy profile measurements using a spectrometer and time profile measurements using a streak camera reveal the dynamics of longitudinal space-charge on MeV-scale electron beams.
1 July 2007 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment