1 December 2017 in Journal of Materiomics
SnSe single crystals have been demonstrated to possess excellent thermoelectric properties. In this work, we demonstrate a grain size control method in growing nanocrystalline SnSe thin films through a glancing angle pulsed-laser deposition approach. Structural characterization reveals that the SnSe film deposited at a normal angle has a preferred orientation along a axis, while by contrast, the SnSe film deposited at an 80° glancing angle develops a nanopillar structure with the growth direction towards the incident atomic flux. The glancing angle deposition greatly reduces the grain size of the thin film due to a shadowing effect to the adatoms, resulting in significantly increased power factor for more than 100%. The maximum Seebeck coefficient and power factor are 498.5μV/K and 18.5μWcm−1K−2, respectively. The enhancement of thermoelectric property can be attributed to the potential barrier scattering at grain boundaries owing to the reduced grain size and increased grain boundaries in the film. Given this enhanced power factor, and considering the fact that the nanopillar structure should have much lower thermal conductivity than a plain film, the zT value of such made SnSe film could be significantly larger than the corresponding single crystal film, making it a good candidate for thin film-based thermoelectric device
29 April 2015 in ECS Meeting Abstracts
Lithium phosphorus oxynitride (LiPON) is one of the promising electrolyte material for the thin-film batteries due to its superior electrochemical stability, moderate ionic conductivity and low electronic conductivity. In addition, LiPON has a wide optical bandgap (>3 eV) which makes it transparent for UV-Vis light and suitable for using in electrochromic thin film devices. The typical value of ionic conductivity of LiPON is in the range of 0.2 to 3.3×10-6 S/cm[1]. Here we report the deposition of amorphous LiPON thin films by RF sputtering from a commercial Li3PO4 target in nigtrogen atmosphere with the ionic conductivities at room temperature as high as 6.5×10-6 S/cm with an activation energy of 0.55 eV. The average growth rate is 14 nm per minute. The electronic conductivity is found to be 2.2×10-12 S/cm. The film composition is determined to be Li3.13PO1.69N1.39by inductively coupled plasma-optical emission spectrometry (ICP-OES) and Rutherford backscattering spectrometry (RBS), which demonstrates our LiPON sample contains relatively high nitrogen content and low oxygen content. The local structure is probed by XPS and Raman spectrometry. The incorporation of nitrogen in the matrix is confirmed by both methods and the nitrogen is present in two different chemical environments corresponding to and P-N=P. The optical properties of LiPON are studied by variable-angle spectroscopic ellipsometry (SE) and transmission measurements. The LiPON film is found to have a bandgap of 3 eV and is highly transparent for UV-VIS light. The optical constants include refractive index n, extinction coefficient k and absorption coefficient α in the energy range of 0.58~5.5 eV are derived. The Urbach tail is also observed in LiPON thin films when photon energy is lower than the bandgap. For its application in electrochromic device, the WO3/LiPON half-cells are prepared and the electrochromic properties will be discussed. [1] J.F. Ribeiro, R. Sousa, J.P. Carmo, L.M. Gonçalves, M.F. Silva, M.M. Silva, J.H. Correia, Thin Solid Films 522 (2012) 85-89.