Chalcogen vacancy defects in monolayer transition metal dichalcogenides form in-gap states that can trap excitons, leading to defect-mediated photoluminescence (PL) emission. Here, we show that room-temperature (RT, 300 K) PL from sulfur vacancies in defective monolayer MoS2 is sensitive to doping from dielectric substrates such as SiO2 and HfO2. The defect-mediated PL is observed for monolayer MoS2 on untreated HfO2 but is quenched on untreated SiO2, which is attributed to electron doping of MoS2 on SiO2. Electron doping of MoS2 is confirmed by Raman and synchrotron X-ray photoelectron spectroscopy. Annealing of the SiO2 substrate modifies its surface states, which is reflected in the recovery of the defect-mediated PL emission. The role of substrate-induced doping on sulfur vacancy-mediated PL is further supported by gate-dependent PL measurements. Our results suggest that excess electrons fill the defect energy states from sulfur vacancies in MoS2, reducing the probability of photoexcited carrier occupation and subsequent defect-mediated emission.
Van der Waals heterostructures (vdW-HSs) integrate dissimilar materials to form complex devices. These rely on the manipulation of charges at multiple interfaces. However, at present, submicrometer variations in strain, doping, or electrical breakages may exist undetected within a device, adversely affecting macroscale performance. Here, we use conductive mode and cathodoluminescence scanning electron microscopy (CM-SEM and SEM-CL) to investigate these phenomena. As a model system, we use a monolayer WSe2 (1L-WSe2) encapsulated in hexagonal boron nitride (hBN). CM-SEM allows for quantification of the flow of electrons during the SEM measurements. During electron irradiation at 5 keV, up to 70% of beam electrons are deposited into the vdW-HS and can subsequently migrate to the 1L-WSe2. This accumulation of charge leads to dynamic doping of 1L-WSe2, reducing its CL efficiency by up to 30% over 30 s. By providing a path for excess electrons to leave the sample, near full restoration of the initial CL signal can be achieved. These results indicate that the trapping of charges in vdW-HSs during electron irradiation must be considered, in order to obtain and maintain optimal performance of vdW-HS devices during processes such as e-beam lithography or SEM. Thus, CM-SEM and SEM-CL form a toolkit through which nanoscale characterization of vdW-HS devices can be performed, allowing electrical and optical properties to be correlated.
Titanium carbide MXene (Ti₃C₂T ₓ ) is an emerging metallic material with promise for (opto)electronics and thermal management. Yet how photoexcitation—particularly via photogenerated thermal energy—modifies its charge carrier dynamics remains poorly understood. By combining time-resolved terahertz spectroscopy and transient reflectance measurements, we reveal a long-lived, photo-induced suppression of conductivity, which we attribute to efficient lattice heating and slow heat dissipation in Ti₃C₂T x . A systematic variation of pump photon energy reveals that this ‘negative’ photoconductivity can equivalently be induced by lattice temperature increases, indicating a thermal origin. Repetition-rate-dependent transient reflectance measurements further show residual heat persisting over 100 ns, substantially longer than in conventional metals. Our work presents a unified understanding of photothermal effects in Ti₃C₂T ₓ and their influence on non-equilibrium charge transport, underscoring its potential for photothermal electronics and light-to-thermal energy storage applications.