Hosting both tsunami earthquakes and slow slip events at shallow depth, the northern Hikurangi margin has motivated strong research efforts over the last two decades to better understand the relation between fluid pressure and fault mechanical behavior. Recently, IODP Expeditions 372 and 375 drilled, cored, and logged the basin entering this subduction zone providing a unique opportunity to characterize initial hydrogeological and petrophysical properties that drive seismic hazards along the margin. We inventory bound and interstitial fluid contents and assess the compaction state of the heterogeneous incoming sequence by correcting shipboard total connected porosity from the bound water content that typically characterizes clay‐rich sediments. By combining mercury injection capillary pressure, nuclear magnetic resonance, and nitrogen gas adsorption, we further document the evolution of pore structure with increasing depth. We also compare porosity data at the logging and sample scales. Both logging and laboratory data evidence contrasted porosity, pore structure, and fluid distribution across the entering section. Shallow macroporous siliciclastic units show very low bound water content and undergo compaction‐induced dewatering as they are normally consolidated during burial. In contrast, mesoporous volcaniclastic Hikurangi Plateau facies are characterized by high potential for bound water release from smectite, zeolite, and opal dehydration at greater depths. They mostly exhibit very low permeability except potentially in uncemented highly porous intervals where the décollement may initiate. Macroporous to mesoporous pelagic carbonates sandwiched in between exhibit mixed behavior and may also host the future décollement, similarly to the southern part of the margin.
Several mechanisms involving excess pore pressure related to gas hydrate have been proposed to explain active creeping at landslides such as the north Hikurangi margin Tuaheni Landslide Complex (TLC). Cores and logging data were retrieved by the International Ocean Discovery Program (IODP) Expeditions 372 and 375 from the South TLC at Site U1517. Here, the evolutions of porosity, pore structure and permeability are determined to assess the compaction state in the landslide and compare it with that of the undeformed sequence at Site U1519. Although no evidence of gas hydrate in the landslide at Site U1517 was identified by the cruise, zones suspected to host gas hydrates below the landslide or at Site U1519 are characterised by higher porosity, pore diameter and permeability. We show that most of the sedimentary section is in hydrostatic conditions, except the base of the TLC at Site U1517 and a zone below the base of the gas hydrate stability zone at Site U1519. These zones might be candidates for excess pore pressure build‐up. There is no obvious evidence of the involvement of gas hydrate in active creeping at the TLC, which is more likely induced by hydrogeomechanical processes.
11 October 2021 in Geochemistry, Geophysics, Geosystems
Characterization of the porosity evolution across the sedimentary section entering subduction zones and accreted sediments provide valuable information for understanding the deformation history at accretionary margins and the physico‐chemical processes in and around fault zones. International Ocean Discovery Program Expeditions 372 and 375 drilled, logged, and cored the reference section on the incoming plate (Site U1520) and across the active Pāpaku thrust (Site U1518), which is a <30° westward‐dipping splay fault in the frontal accretionary wedge at the north Hikurangi margin in a region where tsunami earthquakes and recurrent slow slip events are documented. We observe strong variations of physical properties across the thrust fault. In particular, interstitial porosity increases by ∼10% through the fault zone while it exponentially decreases with depth, showing lower values in the hanging‐wall (HW; on average, ∼36%) than in the footwall (∼42%). Based on comparisons of porosity with the compaction curve at Site U1518 with that of reference Site U1520, we infer an overcompaction in the HW and a nearly normal compaction in the footwall of the Pāpaku thrust. We suggest that the porosity pattern across the thrust infers differences in the maximum burial depth of sediments, characterized by an overcompacted HW that has been uplifted, thrusted, and concomitantly tectonically eroded above the footwall. Porosity data indicate hydrostatic conditions around the thrust fault contrasting with commonly assumed excess pore pressure at the plate interface.