21 May 2018 in Mathematical Problems in Engineering
The Stream of Variation (SoV) model and control chart are combined to study the fault diagnosis method of flexible materials R2R manufacturing system. Based on the analysis of the correlation between the fault source and product quality in the manufacturing process and also the statistical distribution rule of the processing quality characteristic vector and the fault source , SoV model under controlled or uncontrolled states and the mathematical model of the probability distribution of the statistic of the quality characteristic variable are deduced. And the calculation equation of the centerline, the upper limit, and the lower limit of the control chart are deduced. The experimental results show that, under controlled or uncontrolled condition, when the program runs to 500 steps, the Average Run Length (ARL) of the performance parameters tends to be stable; and when program reaches 1000 steps, the actual ARL value is almost the same as the theoretical value. The fault diagnosis experiment shows that, under the condition when the fault source is strongly correlated or the fault source correlation coefficient is the same, using the control chart established in this paper can simply and quickly determine the fault location in the system.
23 April 2020 in Mathematical Problems in Engineering
Roll-to-Roll (R2R) processing is a common processing method for flexible photoelectric film materials. Due to the physical properties of the materials, the change in the performance of the R2R processing equipment can easily cause deformation of the flexible film material, it is particularly important to predict the performance degradation of the processing equipment. Based on the accuracy and real-time requirements of performance degradation prediction, a PTS-FNN model for performance degradation prediction was proposed in this paper, which combines the Possibilistic C-Means (PCM) fuzzy clustering and Takagi–Sugeno Fuzzy Neural Network (TS-FNN). We also studied the PCM classification algorithm of input data of PTS-FNN model, the predecessor network of TS-FNN prediction model and the construction method of post-component network. Finally, the implementation process of PCM classification algorithm and TS-FNN prediction model were given. The R2R processing equipment health prediction experiment system was built and the PTS-FNN model experiment was carried out. The experimental results showed that the training time of PTS-FNN model was 50.37% less than the standard TS-FNN prediction model. The prediction accuracy increased by 5.48%, and the PTS-FNN had no error in the judgment of state 1 and state 4.