Hua Ji

Hua Ji

Auto-generated profile, based on publicly available information

Hua Ji

Light Alloy Research Institute, Central South University, Changsha 410083, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 December 2019 in Materials
Verified
Journal Article
Open access
PDF file
SLSen Lin
Sen Lin
JTJianguo Tang
Jianguo Tang
SLShengDan Liu
ShengDan Liu
YDYunlai Deng
Yunlai Deng
HLHuaqiang Lin
Huaqiang Lin
XZXinming Zhang
Xinming Zhang
The microstructures and mechanical properties of friction stir welded (FSW) Al–Zn–Mg alloy plate under different travel speeds were investigated. Both the average grain sizes (AGSs) of the shoulder affected zone (SAZ), nugget zone (NZ), and the widths of thermo-mechanically affected zone (TMAZ) decreased with the increase of travel speed. Moreover, the AGSs of NZ are always about 60% of that of SAZ at different travel speeds. The fractions of high-angle grain boundaries (HAGBs) in the FSW joints reduce with the distance away from the stir zone (SZ). Furthermore, the initial η’ strengthening precipitates in NZ and TMAZ dissolve and GP zones form during subsequent natural aging, so that the hardness is similar in the two zones. The precipitate evolution in the heat-affected zone (HAZ) at hardness minima are affected by travel speeds, which induce the hardness minima and ultimate tensile strength (UTS) of FSW joints and increase with the increase of travel speed, and a fracture tends to occur at hardness minima location of HAZ during tensile testing.

4 July 2018 in Materials
Verified
Journal Article
Open access
PDF file
PWPengfei Wu
Pengfei Wu
YDYunlai Deng
Yunlai Deng
SFShitong Fan
Shitong Fan
HJHua Ji
Hua Ji
XZXinming Zhang
Xinming Zhang
In this paper, the microstructure of friction stir welded between the Al–Li–Cu alloy and the Al–Zn–Mg–Cu alloy was studied using optical microscope(OM), electronic backscattered diffraction (EBSD), SEM, and TEM. The hardness profile revealed that the range of heat affect zone for the Al–Zn–Mg–Cu alloy was slightly wider than the Al–Li–Cu alloy when they suffered from the thermal transient. Additionally, the characterization of precipitates inside the different zones was obviously different, which corresponded to the microhardness distribution profile. At the periphery of the kissing line, the Al–Li–Cu and the Al–Zn–Mg–Cu alloys mutually diffused during the weld process. The magnesium element in the Al–Zn–Mg–Cu alloy diffused into the Al–Li–Cu alloy. But the copper and zinc had no change because of the low diffusion coefficient in aluminum. The heat affected zone of the Al–Zn–Mg–Cu alloy showed a higher corrosion susceptibility immersed into the corrosion environment, and the Al–Li–Cu alloy did not show severe corrosion.