Jun Yang

Jun Yang

Auto-generated profile, based on publicly available information

Jun Yang

Department. of Engineering Physics, Tsinghua University, Beijing 100084, China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2017 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
JYJun Yang
Jun Yang
Wang QiangWang Qiang
Wang Qiang
YZYuqi Zhou
Yuqi Zhou
Plain cement concrete, ground granulated blast furnace slag (GGBS) concrete, and fly ash concrete were designed. Three wet curing periods were employed, which were 2, 5, and 8 days. The drying shrinkage values of the concretes were measured within 1 year after wet curing. The results show that the increasing rate of the drying shrinkage of concrete containing a mineral admixture at late age is higher than that of plain cement concrete regardless of the wet curing time. With the reduction of wet curing time, the increment of total drying shrinkage of concrete decreases with the decrease of the W/B ratio. The negative effects on the drying shrinkage of fly ash concrete due to the reduction of the wet curing time are much more obvious than those of GGBS concrete and plain cement concrete. Superfine ground granulated blast furnace slag (SGGBS) can reduce the drying shrinkage of GGBS concrete and fly ash concrete when the wet curing time is insufficient.

1 January 2017 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
Mengyuan LiMengyuan Li
Mengyuan Li
Wang QiangWang Qiang
Wang Qiang
JYJun Yang
Jun Yang
A comparison was made between the impact of raising the thermostatic temperature and the impact of prolonging the thermostatic time on the performance of steam-cured concrete containing a large portion of fly ash (FA) or ground granulated blast furnace slag (GGBS) by analysing the form removal strength, chemically combined water content, reaction degree, strength development, chloride permeability, and volume stability. For the materials and test conditions reported in this study, raising the thermostatic temperature is more favourable for concrete containing FA, as indicated by the significantly higher form removal strength and the higher growth of reaction degree of FA compared with prolonging the thermostatic time. With an increase in the thermostatic temperature, the hydration degree of a binder containing FA or GGBS initially increases and subsequently decreases. Although concrete containing FA can obtain satisfactory form removal strength with steam curing at 80°C, the late strength development of concrete containing FA is slow for the same curing conditions. The effect of the late performance of resistance to chloride ion permeability improved by FA is better than the effect improved by GGBS. The risk of destroying the structure of concrete containing a large portion of FA or GGBS due to delayed ettringite formation (DEF) is minimal when specimens were steam-cured at 80°C.

1 June 2019 in Journal of Instrumentation
Verified
Journal Article
Open access
PDF file
YFY. Fu
Y. Fu
YTY. Tian
Y. Tian
YLY. Li
Y. Li
YYYAN YANG
YAN YANG
YCY. Cai
Y. Cai
JLJ. Li
J. Li
A neutron time projection chamber can locate the approximate direction of a neutron hot spot with high efficiency and a 4π field of view. The angular resolution can be significantly improved by adding several plastic scintillation detectors and using coincidence events. The specific performances of such a coincidence imaging system are studied based on theoretical calculations and experimental results. The calculated value of the angular resolution is approximately 2o for the current system, which agrees well with the experimental results and sets an upper limit for the angular resolution of traditional back projection based online reconstruction methods. Although the statistical iterative method can breakthrough this limit and further improve the angular resolution, the time consumption is usually a problem. The coincidence imaging system can be further optimized for future applications based on the theoretical model.