Scaffolds based on aligned and non-aligned poly (L-lactic acid) (PLLA)/polycaprolactone (PCL) fibers obtained by electrospinning, associated to electrosprayed hydroxyapatite (HA) for tissue engineering applications were developed and their performance was compared in terms of their morphology and biological and mechanical behaviors. The morphological results assessed by scanning electron microscopy showed a mesh of PLLA/PCL fibers (random and perfectly aligned) associated with aggregates of nanophased HA. Fourier transform infrared spectrometry confirmed the homogeneity in the blends and the presence of nanoHA in the scaffold. As a result of fiber alignment a 15-fold increase in Young’s Modulus and an 8-fold increase in tensile strength were observed when compared to non-aligned fibers. In PLLA/PCL/HA scaffolds, the introduction of nanoHA caused a remarkable improvement of the mechanical strength of this material acting as a reinforcement, enhancing the response of these constructs to tensile stress. In vitro testing was evaluated using osteoblast (MC3T3-E1) cells. The results showed that both fibrous scaffolds were able to support osteoblast cell adhesion and proliferation and that fiber alignment induced increased cellular metabolic activity. In addition, the adhesion and proliferation of Staphylococcus aureus were evaluated and a lower number of colony forming units (CFUs) was obtained in the scaffolds with aligned fibers.
1 February 2019 in Journal of the Mechanical Behavior of Biomedical Materials
Electrospinning is a simple and low-cost way to fabricate fibers. Among the various polymers used in electrospinning, polycaprolactone (PCL) stands out due to its excellent biodegradability and biocompatibility. However, PCL has some limitations such as low bioactivity, hydrophobic surface, and long in vivo degradation. Calcium phosphate ceramics have been recognized as an attractive biomaterial. They are bioactive and osteoinductive, and some are even quite biodegradable. Different contents of particles of beta-tricalcium phosphate (β-TCP) were incorporated in polymer matrix to form fibers of PCL/β-TCP composites by electrospinning for possible application in tissue regeneration. The presence of β-TCP particles promoted some changes in the thermal properties of the fibers. The immersion of PCL/β-TCP 8 wt-% fibers in simulated body fluid (SBF) caused the formation of a denser and homogeneous apatite layer on its surface.
Replacement tissues for tissue engineering can be produced by seeding human cells onto scaffolds. In order to guarantee adequate bio-compatibility, porosity and mechanical resistance for promoting cellular growth, proliferation and differentiation within scaffold structures, it is necessary to investigate and improve materials and processing routes. β-tricalcium phosphate can be considered a very suitable bio-ceramic material for bone therapy because of its biocompatibility, osteo-conductivity and neo-vascularization potential. Alumina is commonly used as a sintering additive. In this study, β-TCP and β-TCP/Al2O3 scaffolds were obtained by gel-casting method. The scaffolds showed high porosity (86-88%) and pore sizes ranging from 200 to 500 µm. Even though alumina did not promote improvement in β-TCP/Al2O3 scaffolds in terms of mechanical performance, they showed great cytocompatibility as there was no cytotoxic and genotoxic effect. Therefore, β-TCP and β-TCP/Al2O3 scaffolds are good candidates for application in tissue engineering.