30 July 2020 in Environmental Chemistry Letters
Climate change is defined as the shift in climate patterns mainly caused by greenhouse gas emissions from natural systems and human activities. So far, anthropogenic activities have caused about 1.0 °C of global warming above the pre-industrial level and this is likely to reach 1.5 °C between 2030 and 2052 if the current emission rates persist. In 2018, the world encountered 315 cases of natural disasters which are mainly related to the climate. Approximately 68.5 million people were affected, and economic losses amounted to $131.7 billion, of which storms, floods, wildfires and droughts accounted for approximately 93%. Economic losses attributed to wildfires in 2018 alone are almost equal to the collective losses from wildfires incurred over the past decade, which is quite alarming. Furthermore, food, water, health, ecosystem, human habitat and infrastructure have been identified as the most vulnerable sectors under climate attack. In 2015, the Paris agreement was introduced with the main objective of limiting global temperature increase to 2 °C by 2100 and pursuing efforts to limit the increase to 1.5 °C. This article reviews the main strategies for climate change abatement, namely conventional mitigation, negative emissions and radiative forcing geoengineering. Conventional mitigation technologies focus on reducing fossil-based CO2 emissions. Negative emissions technologies are aiming to capture and sequester atmospheric carbon to reduce carbon dioxide levels. Finally, geoengineering techniques of radiative forcing alter the earth’s radiative energy budget to stabilize or reduce global temperatures. It is evident that conventional mitigation efforts alone are not sufficient to meet the targets stipulated by the Paris agreement; therefore, the utilization of alternative routes appears inevitable. While various technologies presented may still be at an early stage of development, biogenic-based sequestration techniques are to a certain extent mature and can be deployed immediately.
1 November 2020 in Renewable Energy
1 August 2004 in International Journal of Refrigeration
1 May 2005 in International Journal of Refrigeration
13 September 2023 in Journal of Ocean Engineering and Science
1 May 1999 in Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy
Following on from experimental data already presented by Spence and Artt in 1997, further comprehensive performance tests were carried out on a 99.0 mm radial turbine with three larger vaned stators. The results have helped to confirm some of the trends noted in the earlier tests. Measurements of the efficiency, mass flowrate and rotor pressure ratio are presented together with the results of a simple loss analysis. For smaller stator sizes the turbine mass flowrate is shown to be proportional to the stator throat area. The significance of the stator-rotor throat area ratio is examined and its dependence on the stage pressure ratio is noted.