The South China Sea is a major shipping hub between the West Pacific and Indian Oceans. In this region, the demand for energy is enormous, both for residents’ daily lives and for economic development. Wave energy and wind energy are two major clean and low-cost ocean sources of renewable energy. The reasonable development and utilization of these energy sources can provide a stable energy supply for coastal cities and remote islands of China. Before wave energy and wind energy development, however, we must assess the potential of each of these sources. Based on high-resolution and high-accuracy wave field data and wind field data obtained by ERA-Interim reanalysis for the recent 38-year period from 1979–2016, the joint development potential of wave energy and wind energy was assessed in detail for offshore and nearshore areas in the South China Sea. Based on potential installed capacity, the results revealed three promising areas for the joint development of nearshore wave energy and wind energy, including the Taiwan Strait, Luzon Strait and the sea southeast of the Indo-China Peninsula. For these three dominant areas (key stations), the directionality of wave energy and wind energy propagation were good in various seasons; the dominant wave conditions and the dominant wind conditions were the same, which is advantageous for the joint development of wave and wind energy. Existing well-known wave energy converters (WECs) are not suitable for wave energy development in the areas of interest. Therefore, we must consider the distributions of wave conditions and develop more suitable WECs for these areas. The economic and environmental benefits of the joint development of wave and wind energy are high in these promising areas. The results described in this paper can provide references for the joint development of wave and wind energy in the South China Sea.
Synthetic aperture radar (SAR) can extract sea surface wind speed information. To extract wind speed information through the geophysical model function (GMF), the corresponding wind direction information must be input. This article introduces some concepts about networked SAR satellites. The networked satellites enable multiple SARs to observe the same sea surface at different incidence angles at the same time. Aiming at the X-band networked SAR data with different incident angles, the cost function is established by using the GMF. By minimizing the cost function, accurate wind speed information can be extracted without inputting wind direction information. When the noise is small, the wind direction information is introduced, and the accuracy of the extracted wind speed will be improved. When the noise is less than 1 dB and the incident angle is greater than 30°, the root-mean-square error (RMSE) of the wind speed extracted by this method is basically less than 2 m/s.
Due to the nonlinear effect of velocity bunching modulation, azimuth cutoff occurs when waves are propagating along the azimuth direction. This is an inherent disadvantage of synthetic aperture radar (SAR) wave observation and makes it impossible to obtain complete wave information. For a single SAR observation, the problem of the azimuth cutoff wavelength of ocean waves can be solved to some extent by the cooperative observations of SAR satellites. It is necessary to use multiple SAR satellites to achieve simultaneous observation of the same ocean area to obtain multiview SAR ocean wave synchronization data. At present, it is impossible to acquire multiview synchronization data based on in-orbit SARs. Therefore, this paper first carried out imaging simulations of multiview SAR ocean wave synchronization data. Second, the MPI method was used to obtain the optimum wave spectrum of synchronous data. The influencing factors of the azimuth cutoff wavelength were analyzed by using the measured SAR data. Based on the analysis results, a new method of multiview wave spectrum data fusion is proposed to realize azimuth cutoff compensation. The azimuth cutoff compensation effect is evaluated by using the inversion results of the azimuth cutoff before and after spectral data fusion, the significant wave height and the mean wave period. The results show that the azimuth cutoff compensation method established in this paper can solve the problem of information loss caused by azimuth cutoff to some extent, improve the ability of SAR wave observation, and lay a foundation for SAR wave operational observation.