The extension of a photonic integrated circuit foundry process flow is proposed by integrating selective area growth (SAG) to enable bandgap tuning for each individual active building block. The process adaptations and the impact on performance are reviewed in terms of morphology requirements and topology reduction. This platform extension enables bandgap tuning for a set of active devices to cover the wavelength range from 1453 to 1651 nm. Integration is demonstrated in combination with active-passive butt-joint technology to create the most comprehensive range of generic building blocks. Performance and limitations of the range of achievable band-edges within the same monolithic wafer are studied for amplifiers and extended cavity lasers.
9 July 2019 in IEEE Journal of Selected Topics in Quantum Electronics
This work demonstrates the integration of buried heterostructure (BH) lasers and semiconductor optical amplifiers (SOAs) in a generic photonic platform. The process-flow necessary for their integration is presented. BH Fabry-Perot lasers fabricated within the platform are fully characterized and compared with shallow-ridge (SR) lasers already available as a standard building block. BH and SR lasers were fabricated on the same wafer sharing the same layer stack. BH lasers showed a reduction in threshold current of 60% and of 40% of thermal resistance. The full integration is then validated by the characterization of a compact an arrayed waveguide grating (AWG) laser-based transmitter consisting of 8 BH-SOAs and a deep-ridge waveguide. The measured free-spectral range (FSR) of the AWG-laser is 900 GHz and the measured channel spacing is 100 GHz. The laser has a threshold current of 15 mA and shows a stable single-mode operation around the central order of the AWG. A side-mode suppression ratio (SMSR) of 57 dB and a linewidth of 1.5 MHz have been achieved.
29 September 2022 in IEEE Journal of Selected Topics in Quantum Electronics
We present experimental studies of semiconductor optical amplifiers with a high integration density in an InP generic photonic integration platform. We study the active-passive butt-joint integration of dense arrays of active islands with widths ranging from 2 to 30 $\mu$ m, and pitches ranging from 4 to 270 $\mu$ m. We show that reducing the active island width from 20 $\mu$ m to 4 $\mu$ m enables a decrease of pitch by almost 4 times while keeping a similar growth rate enhancement (GRE) in between the active islands. The impact of narrow active islands on amplifier performance is also studied with an array of Fabry-Pérot lasers fabricated in a commercial generic platform. We demonstrate the manufacturability of lasers with a pitch of 25 $\mu$ m and evaluate individual device performance. Threshold currents and slope efficiencies are not impaired with narrow active island down to 6 $\mu$ m, with values of 19-26 mA and 0.08-0.15 W/A respectively.
An array of monolithic wide-tunable lasers is integrated using selective area growth to shift the bandgap of their gain section. A gap-free tuning is demonstrated from the combination of the tuning ranges of the lasers, and single-mode operation is verified.
We present finite difference thermal modeling to predict temperature distribution, heat flux, and thermal resistance inside lasers with different waveguide geometries. We provide a quantitative experimental and theoretical comparison of the thermal behavior of shallow-ridge (SR) and buried-heterostructure (BH) lasers. We investigate the influence of a split heat source to describe p-layer Joule heating and nonradiative energy loss in the active layer and the heat-sinking from top as well as bottom when quantifying thermal impedance. From both measured values and numerical modeling we can quantify the thermal resistance for BH lasers and SR lasers, showing an improved thermal performance from 50K/W to 30K/W for otherwise equivalent BH laser designs.