Analog and Mixed Signal Center, Electrical and Computer Engineering Department, Texas A&M University, College Station, TX 77843 USA. He is now with Kioxia Corporation, Kawasaki 212-0013, Japan
Auto-generated profile, based on publicly available information
Takayuki Iwai
Analog and Mixed Signal Center, Electrical and Computer Engineering Department, Texas A&M University, College Station, TX 77843 USA. He is now with Kioxia Corporation, Kawasaki 212-0013, Japan
This paper presents a four-level pulse amplitude modulation (PAM4) quarter-rate receiver that efficiently compensates for moderate channel loss in a robust manner through background adaptation of the receiver thresholds and equalization taps. The front-end utilizes an input single-stage continuous-time linear equalizer (CTLE) to boost the main cursor and relax the pre-cursor cancellation requirement, requiring only a 2-tap pre-cursor feed-forward equalizer (FFE) on the transmitter side. A 2-tap decision feedback equalizer (DFE) follows that includes one finite impulse response (FIR) tap and one infinite impulse response (IIR) tap to cancel first post-cursor and long-tail inter-symbol interference (ISI), respectively. In addition to the per-slice main three data samplers, a single error sampler is utilized for background threshold control and an edge-based sampler performs both phase-locked loop (PLL)-based clock and data recovery (CDR) phase detection and generates information for background DFE tap adaptation. Fabricated in general purpose (GP) 65-nm CMOS, the 56-Gb/s receiver achieves 4.63 mW/Gb/s and compensates for up to 20.8-dB loss at a bit error rate (BER) <; 10 -12 when operated with a 2-tap FFE transmitter.
13 December 2019 in IEEE Journal of Solid-State Circuits
Increased bandwidth per pin is necessary to support the growing data throughput in mobile systems. This article presents a low-power simultaneous bidirectional (SBD) transceiver employing a novel voltage-mode driver with a resistor-transconductance (R-gm) hybrid subtractor to enable concurrent transmission and reception of data on a single differential channel. A finite impulse response (FIR) filter-based adaptive echo cancellation system that cancels both near- and far-end echoes allows for the support of a wide range of channels, while a continuous-time linear equalizer (CTLE) efficiently compensates for channel loss. The quarter-rate source-synchronous transceiver utilizes a low-complexity phase interpolator-based clock and data alignment system to set the optimum data sampling point. Fabricated in 28-nm CMOS, the 32-Gb/s SBD transceiver achieves 1.83 mW/Gb/s and compensates 10.2-dB loss at a bit error rate (BER) <10⁻¹².
Utilizing four-level pulse-amplitude modulation (PAM-4) with vertical-cavity surface emitting lasers (VCSELs) is challenging due to device nonlinearity and bandwidth limitations. This paper presents a VCSEL-based PAM-4 transmitter that employs a 2.5-tap nonlinear equalizer to compensate for these issues. The transmitter utilizes lookup-table control of a current-mode digital-to-analog converter (DAC) output stage to enable independent equalization coefficients for the different PAM-4 symbol transitions. Utilizing half pre-cursor (MSB only), one main, and one post-cursor taps provides a good balance between circuit complexity and performance. Equalization resolution is increased by segmenting the output stage into a 2-bit symbol DAC and a fine 3-bit equalization DAC. Fabricated in GP 65nm CMOS, the serializing transmitter operates at 50 Gb/s with 3 dBm optical modulation amplitude (OMA) when driving an 11 GHz VCSEL and achieves 5.12 pJ/bit power efficiency.