In recent years, acoustic emission (AE) sensors and AE-based techniques have been developed and tested for gearbox fault diagnosis. In general, AE-based techniques require much higher sampling rates than vibration analysis-based techniques for gearbox fault diagnosis. Therefore, it is questionable whether an AE-based technique would give a better or at least the same performance as the vibration analysis-based techniques using the same sampling rate. To answer the question, this paper presents a comparative study for gearbox tooth damage level diagnostics using AE and vibration measurements, the first known attempt to compare the gearbox fault diagnostic performance of AE- and vibration analysis-based approaches using the same sampling rate. Partial tooth cut faults are seeded in a gearbox test rig and experimentally tested in a laboratory. Results have shown that the AE-based approach has the potential to differentiate gear tooth damage levels in comparison with the vibration-based approach. While vibration signals are easily affected by mechanical resonance, the AE signals show more stable performance.
29 September 2014 in Annual Conference of the PHM Society
Fabrication of three-dimensional (3D) objects through direct deposition of functional materials using 3D printing equipment is called additive manufacturing (AM). Benefits of AM include producing goods quickly and on-demand, with greater customization and complexity and less material waste. While the use of AM has been growing, a number of challenges continue to impede its more widespread adoption, particularly in the areas of non-destructive evaluation/non- destructive testing (NDE/NDT) techniques for AM equipment health monitoring and measurement. In this paper, a prognostics and health management (PHM) approach to AM equipment health monitoring, fault diagnosis and quality control is presented and illustrated with a case study. The presented PHM approach is developed using two types of NDE/NDT sensors: acoustic emission (AE) sensor and piezoelectric strain sensor. A seeded driving belt fault on a fused filament fabrication desktop 3D printer is used to validate the feasibility of the PHM approach in the case study. The case study results have shown the effectiveness of the presented method for AM equipment fault diagnosis and quality control.
29 September 2014 in Annual Conference of the PHM Society
Planetary gearboxes are widely used in the drivetrain of helicopters and wind turbines. Any planetary gearbox failure could lead to breakdown of the whole drivetrain and major loss of helicopters and wind turbines. Therefore, planetary gearbox fault diagnosis is an important topic in prognostics and health management (PHM). Planetary gearbox fault diagnosis has been done mostly through vibration analysis over the past years. Vibration signals theoretically have the amplitude modulation effect caused by time variant vibration transfer paths due to the rotation of planet carrier and sun gear, and therefore their spectral structure is complex. It is difficult to diagnose planetary gearbox faults via vibration analysis. Strain sensor signals on the other hand have less amplitude modulation effect. Thus, it is potentially easy and effective to diagnose planetary gearbox faults via stain sensor signal analysis. In this paper, a research investigation on planetary gearbox fault diagnosis via strain sensor signal analysis is reported. The investigation involves using time synchronous average technique to process signals acquired from a single piezoelectric strain sensor mounted on the housing of a planetary gearbox and extracting condition indicators for fault diagnosis. The reported investigation includes analysis results on a set of seeded fault tests performed on a planetary gearbox test rig in a laboratory. The results have showed a satisfactory planetary gearbox fault diagnostic performance using strain sensor signal analysis.