We report on the InAs quantum dots (QDs) laser in the wavelength region grown by gas source molecular-beam epitaxy. The active region of the laser structure consists of fivefold-stacked InAs QD layers embedded in the InGaAsP layer. Ridge waveguide lasers were processed and continuous-wave mode operation was achieved between 20 and , with characteristic temperature of . High internal quantum efficiency (56%) and low infinite length threshold current density ( per QD layer) was obtained for the as-cleaved devices at room temperature. The lasing wavelength range between 1.556 and can be covered by varying the laser cavity length.
An InAs/GaAs quantum dot infrared photodetector (QDIP) based on p-type valence-band intersublevel hole transitions as opposed to conventional electron transitions is reported. Two response bands observed at 1.5–3 and 3–10 μm are due to transitions from the heavy-hole to spin-orbit split-off QD level and from the heavy-hole to heavy-hole level, respectively. Without employing optimized structures (e.g., the dark current blocking layer), the demonstrated QDIP displays promising characteristics, including a specific detectivity of /W and a quantum efficiency of 17%, which is about 5% higher than that of present n-type QDIPs. This study shows the promise of utilizing hole transitions for developing QDIPs.
Hole transitions from the heavy-hole to the light-hole band contributing to the response range are reported on detectors. The detectors show a spectral response up to , operating up to a temperature of 330 K where the response is superimposed on the free-carrier response. Two characteristic peaks observed between are in good agreement with corresponding energy separations of the and bands and thus originated from transitions. Results will be useful for designing multi-spectral detection which could be realized on a single structure.
We report the formation of large ramified gold aggregates after deposition of Au on melting glass surfaces. The growth mechanism of the aggregates is traced to a two-stage process, the first of which involves nucleation and growth of compact Au clusters. The average diameter of the clusters is around 1.2 μm, which is approximately independent of the deposition rate. In the subsequent stage, the clusters diffuse randomly on the colloid surface and the diffusion coefficient is in the range between and Finally they aggregate. It is found that the structure of the aggregates strongly depends on the aggregation time.