This paper presents the results of an inspection campaign as well as condition evaluation and replacement of more than 1000 elastomeric bridge bearings under service on the Isfahan state highway bridges constructed before 1990. It is the first comprehensive survey of this kind. The research was accomplished through inspection surveys, analysis of existing bridge maintenance data, condition evaluation and replacement of a significant portion of the inspected bearings and expert interviews. Inspection surveys and analysis of extracted data identified the problems and their causes and the merits and potential improvement of performance of each one of the inspected elastomeric bearings. Replacement of the damaged bearings with new ones was performed based on the results of this stage. The expert interviews investigated the practices of Isfahan and surrounding states regarding the selection of bearing manufacturers, the performance and the quality control of elastomeric bearings.
1 September 2012 in Structure and Infrastructure Engineering
A set of fragility curves of a class of reinforced concrete bridges with different degrees of irregularity has been generated. Eighteen bridge configurations have been identified, from regular to so-called highly irregular models. The geometric irregularity in this class of bridges is assumed to vary with the height of the piers. Using non-linear analytical models and an appropriate suite of 60 ground motions, analytical fragility curves have been generated for the individual piers of each of these 18 bridge models. Discussions have been made about the imposition of the displacement ductility demand of the piers versus the earthquake intensity as well as the bridge regularity. Comparison of the fragility curves shows that the most vulnerable bridges are the irregular bridges and high damage probability is expected for the short piers of this class of bridges. It was found that the fragility curves may be used for categorisation of regular and irregular bridges.
Several definitions have been used concerning structural regularity. A structure is considered here as regular, if its responses obtained from different well recognized analysis methods do not show significant differences. In this paper, the effects of the inclusion of higher modes on the response of a class of reinforced concrete viaducts with different degrees of irregularity have been investigated. The seismic responses of continuous span single-column-bent viaducts have been studied through the comparison of the results obtained from different pushover-based analysis methods. Commonly used single and multi-mode pushover-based analysis methods have been utilized and their corresponding results have been compared with the results obtained from simpler methods such as the so-called uniform load procedure, as well as the more sophisticated inelastic time history analysis methods. For the class of the bridges under consideration, those configurations for which the effects of the higher modes are considerable have been identified and categorized as irregular, for which the minimum analysis requirements have been indicated in order to achieve a reliable bridge response. In contrast, the conditions in which a configuration may be classified as regular have been demonstrated and the adequacy of the simplified methods for the analysis of such models has been examined. The regularity issue has been discussed initially based on an expression developed by other researchers. Another index has also been introduced here for the attainment of a more realistic representation of the structural particulars of such bridges consist with the analysis methods specified in the AASHTO Specifications.
A structure is considered to be irregular in this paper if its response is influenced considerably by higher modes. Herein, the effects of the higher modes on the geometric regularity of single-column-bent viaducts have been investigated by comparing
10 November 2020 in Structure and Infrastructure Engineering
The effects of earthquake incidence angle on the seismic fragility of highway bridges of unequal pier heights are investigated. A variety of configurations from regular to so-called highly irregular models are considered. In order to accurately quantify the uncertainties in the modeling process, the most influential sources related to the material properties, earthquake characteristics and structural geometries are considered in the nonlinear simulation. Several three-dimensional bridge models are simulated in OpenSees platform, and a set of strong ground motion records are employed in a series of nonlinear time history analyses of the bridge models. Different incidence angle of the records have been used to investigate the response of the models and to extract the most critical engineering demand parameters. The system and component fragility parameters are developed and compared for different values of the excitation angles for all the bridge models. Given the wide range of variables used here, a conversion coefficient is proposed to convert the bridge response for different incidence angles to critical response.