This paper presents an investigation of the dynamics of drilling a visually transparent media using a CO2 laser source. This enabled the use of a high-speed imaging system for observing, in real time, the behaviour of the drilling process below the workpiece surface. The work revealed that the transient drilling velocity within each laser pulse can vary considerably from the steady state drilling velocity as a result of the temporal pulse shape and the oscillation of the melt ejection rate. During beam breakthrough, both upward and downward melt ejections were observed to occur inside the hole cavity for a short period of time, after which the material was ejected downwards only. It has been shown in this work that the downward melt flow velocity increases with hole depth for a positive taper hole geometry (0.09-1.43 ms−1) and decreases with hole depth for a negative hole geometry from 0.4 to 0.1 ms−1, as a result of the change in the assist gas velocity inside the hole cavity with respect to the hole taper geometry. The mechanisms of forming the positive and negative tapered holes in the transparent media have been correlated with the hole geometry and melt flow velocity.
In laser percussion drilling, holes are produced mainly by melt ejection with a series of laser pulses. The circularity of the holes not only depends on various laser-processing parameters but also their interactions that influence the characteristics of melt ejection. In this work a statistical modelling approach was used to study the effects of six processing variables (peak power, pulse width, pulse frequency, number of pulses, assist gas pressure and focal plane position) and their interactions on the hole circularity. Response surface method was used to statistically analyse the process. For each variable five levels were considered and the experiments were conducted based on a Central Composite Design (CCD). The experiments were performed using an optical fibre delivered Nd:YAG laser drilling on mild steel sheets of 2.5 mm thickness. An analysis of variance (ANOVA) was performed to test the significance of the variables at 1% and 7% levels. It was found that pulse width has a significant effect on the hole entrance circularity. Pulse frequency and number of pulses have very little effect on the hole entrance circularity.
Most glasses are typically transparent to laser irradiation at near-infrared wavelengths. However, when a near-infrared femtosecond laser beam is focused inside a transparent material, the intensity in the focal volume can become high enough (1014 W cm−2) to cause nonlinear absorption, avalanche ionisation and microplasma formation. If sufficient energy is deposited, permanent structural change can occur, leading to a change in refractive index. In this work, investigations were conducted on the use of femtosecond laser pulses at 775 nm wavelength to induce localised refractive index changes in aluminosilicate glass that function as optical waveguides. The effects of laser pulse energy, writing speed and number of scans on the magnitude of the resultant refractive index change and dimensions of the modified structures were studied. The fabrication of potential waveguide devices was investigated and characterised.