The present research focuses on analyzing the uniaxial compressive strength of rocks and its relationship with point load index testing. It is important to note that Seybaplaya, located in Campeche Mexico, is recognized for its fishing, industrial and commercial activities and where a rock bench is located from which samples were obtained to carry out the study. As a result, equations were developed that allow predicting the simple uniaxial compressive strength based on the values obtained from the point load index test. It is relevant to highlight that these relationships are valid only for rocks with lithological characteristics similar to those used in this study. The analysis results and conclusions demonstrate the linearity of the relationships between the simple uniaxial compressive strength and the point load index test.
30 June 2024 in Revista de Aplicaciones de la Ingeniería
This research study focuses on analyzing the uniaxial compressive strength of rocks and its correlation with non-destructive testing (Schmidt hammer) and specific gravity. It is important to note that Seybaplaya, located in Campeche, Mexico, is known for its fishing, industrial, and commercial activities. Samples from one of the main active quarries in the state of Campeche were used for the investigation. As a result, equations were developed to predict the simple uniaxial compressive strength based on values obtained from the Schmidt hammer and specific gravity. It is relevant to highlight that these relationships are only valid for rocks with lithological characteristics similar to those used in this study. The results of the analysis and the conclusions demonstrate the non-linearity of the relationships between simple uniaxial compressive strength, non-destructive testing, and specific gravity.
An analysis and structural design of strength and ductility level earthquake is presented in this paper. Numerical results show that structural failure under seismic loads is sensitive to the degree of deterioration of structural steel. The structural elements do not present any excess stress, that is, all stress ratios are less than unity. The maximum stress ratio is 0.942, in the superstructure of element 1586-1571, which corresponds to a main deck beam elevation (+) 15,850 m.
The present research focuses on analyzing the uniaxial compressive strength of rocks and its relationship with the indirect tensile test (the Brazilian method). It is important to note that Seybaplaya, located in Campeche, Mexico, is known for its fishing, industrial and commercial activities, and is home to a rock bank from which samples were obtained for this study. As a result, an equation was developed that allows predicting the simple uniaxial compressive strength from the values obtained in the indirect tensile test. It should be noted that this relationship is valid only for rocks with similar lithological characteristics of the samples analyzed. The results of the analysis and conclusions show the linearity of the relationship between the simple uniaxial compression resistance and the indirect tensile test.
30 December 2024 in Journal of Research and Development
This research work analyzed the properties of stone aggregates, focusing on uniaxial compressive strength, point load strength tests and indirect tensile test.Seybaplaya, a port in Campeche, Mexico, was the site of sample collection from an active bank. The results showed that the compression varied between 8.6 - 84.7 MPa, the point load between 0.52 - 7.12 MPa, and the indirect tension between 0.672 - 10.839 MPa. These properties are essential for designers and builders, providing guidance on the importance of aggregates in structures.
The useful life of an infrastructure depends on the preventive maintenance provided during its use, however, abandonment due to various situations accelerates the deterioration of the elements that comprise it, so it is necessary to rehabilitate them by carrying out mandatory modeling and simulation in the real conditions in which the structure is located. Therefore, this work shows the modeling under real corrosion conditions of structural profiles that make up the support system of the steps of a stadium. It is determined that all the structural elements that make up the educational infrastructure require reinforcements due to the reduction in thickness due to corrosion, this is because the portable capacity of the stadium is reduced.