The widespread adaptation of systems relying on optically controlled quantum information will require reliable and efficient multi-channel fiber-to-chip connections that function at cryogenic temperatures. Here we demonstrate low loss (2 dB per channel) connections between a single mode fiber array and tapered silicon waveguides down to 5 K using polymer based photonic wire bonds (PWBs). A method is described for assembling the silicon chip and fiber array such that the PWB connections are robust to temperature cycling and cryostat bakeout. The threshold power handling capability of the PWBs is greater than 4 dBm, sufficient to demonstrate optical bistability in silicon microring resonators coupled to the waveguides at 5 K.
We present a new fab-in-the-loop reinforcement learning algorithm for the design of nano-photonic components that accounts for the imperfections present in nanofabrication processes. As a demonstration of the potential of this technique, we apply it to the design of photonic crystal grating couplers fabricated on an air clad 220 nm silicon on insulator single etch platform. This fab-in-the-loop algorithm improves the insertion loss from 8.8 to 3.24 dB. The widest bandwidth designs produced using our fab-in-the-loop algorithm can cover a 150 nm bandwidth with less than 10.2 dB of loss at their lowest point.
The tunneling dynamics of photogenerated holes in a biased GaAs/AlGaAs double-barrier resonant tunneling structure is studied using time-resolved photoluminescence. For voltages biasing the structure in the resonant tunneling regime, a single exponential time decay was observed. However, for voltages which bias the structure in the nonresonant tunneling regime, beyond the region of negative differential resistance, the exciton decays with two time constants: one similar to that observed at low voltages and one that is approximately one order of magnitude slower. We attribute the fast time constant to the decay of exciton population originating from holes photoexcited directly in the well. The slower time constant is associated with excitons that are created from holes which are photoexcited in the GaAs contact region, and which subsequently tunnel into the well.
Superconducting nanowire single-photon detectors are widely used for detecting individual photons across various wavelengths from ultraviolet to near-infrared range. Recently, there has been increasing interest in enhancing their sensitivity to single photons in the mid-infrared spectrum, driven by applications in quantum communication, spectroscopy, and astrophysics. Here, we present our efforts to expand the spectral detection capabilities of U-shaped NbTiN-based superconducting nanowire single-photon detectors, fabricated in a 2-wire configuration on a silicon-on-insulator substrate, into the mid-infrared range. We demonstrate saturated internal detection efficiency extending up to a wavelength of 3.5 μm for a 5 nm thick and 50 nm wide NbTiN nanowire with a dark count rate less than 10 counts per second at 0.9 K and a rapid recovery time of 4.3 ns. The detectors are engineered for integration on waveguides in a silicon-on-insulator platform for compact, multi-channel device applications.
The influence of electron-hole pairs on free-carrier–LO-phonon interactions in GaAs quantum wells has been studied from the lattice perspective using a visible laser and Raman scattering to monitor LO-phonon dynamics following hot-carrier injection and relaxation. The LO-phonon dynamics were systematically studied as the density of a cold free-carrier population was controlled using an infrared laser. The lifetime of small-wave-vector LO phonons decreases from 4.5 to 1.9 ps as the cold carrier density increases to ∼3× , and there is a corresponding reduction in their nonequilibrium occupation number. These results provide direct evidence of hot-phonon reabsorption and a reduction in the cooling rate from the hot-carrier–LO-phonon system to the lattice bath.
1 May 1994 in Semiconductor Science and Technology