17 March 2020 in Geoscientific Model Development
Here we present a description of the UKCA StratTrop chemical mechanism, which is used in the UKESM1 Earth system model for CMIP6. The StratTrop chemical mechanism is a merger of previously well-evaluated tropospheric and stratospheric mechanisms, and we provide results from a series of bespoke integrations to assess the overall performance of the model. We find that the StratTrop scheme performs well when compared to a wide array of observations. The analysis we present here focuses on key components of atmospheric composition, namely the performance of the model to simulate ozone in the stratosphere and troposphere and constituents that are important for ozone in these regions. We find that the results obtained for tropospheric ozone and its budget terms from the use of the StratTrop mechanism are sensitive to the host model; simulations with the same chemical mechanism run in an earlier version of the MetUM host model show a range of sensitivity to emissions that the current model does not fall within. Whilst the general model performance is suitable for use in the UKESM1 CMIP6 integrations, we note some shortcomings in the scheme that future targeted studies will address.
3 September 2019 in Atmospheric Chemistry and Physics
Indonesia contains large areas of peatland that have been drained and cleared of natural vegetation, making them susceptible to burning. Peat fires emit considerable amounts of carbon dioxide, particulate matter (PM) and other trace gases, contributing to climate change and causing regional air pollution. However, emissions from peat fires are uncertain, due to uncertainties in emission factors and fuel consumption. We used the Weather Research and Forecasting model with chemistry and measurements of PM concentrations to constrain PM emissions from Indonesian fires during 2015, one of the largest fire seasons in recent decades. We estimate primary PM2.5 (particles with diameters less than 2.5 µm) emissions from fires across Sumatra and Borneo during September–October 2015 were 7.33 Tg, a factor 3.5 greater than those in the Fire Inventory from NCAR (FINNv1.5), which does not include peat burning. We estimate similar dry fuel consumption and CO2 emissions to those in the Global Fire Emissions Database (GFED4s, including small fires) but PM2.5 emissions that are a factor of 1.8 greater, due to updated PM2.5 emission factors for Indonesian peat. Fires were responsible for an additional 3.12 Tg of secondary organic aerosol formation. Through comparing simulated and measured PM concentrations, our work provides independent support of these updated emission factors. We estimate peat burning contributed 71 % of total primary PM2.5 emissions from fires in Indonesia during September–October 2015. We show that using satellite-retrieved soil moisture to modify the assumed depth of peat burn improves the simulation of PM, increasing the correlation between simulated and observed PM from 0.48 to 0.56. Overall, our work suggests that peat fires in Indonesia produce substantially greater PM emissions than estimated in current emission inventories, with implications for the predicted air quality impacts of peat burning.
14 January 2020 in Atmospheric Chemistry and Physics
Fine particulate matter (PM2.5) and surface ozone (O3) are major air pollutants in megacities such as Delhi, but the design of suitable mitigation strategies is challenging. Some strategies for reducing PM2.5 may have the notable side effect of increasing O3. Here, we demonstrate a numerical framework for investigating the impacts of mitigation strategies on both PM2.5 and O3 in Delhi. We use Gaussian process emulation to generate a computationally efficient surrogate for a regional air quality model (WRF-Chem). This allows us to perform global sensitivity analysis to identify the major sources of air pollution and to generate emission-sector-based pollutant response surfaces to inform mitigation policy development. Based on more than 100 000 emulation runs during the pre-monsoon period (peak O3 season), our global sensitivity analysis shows that local traffic emissions from the Delhi city region and regional transport of pollution emitted from the National Capital Region (NCR) surrounding Delhi are dominant factors influencing PM2.5 and O3 in Delhi. They together govern the O3 peak and PM2.5 concentration during daytime. Regional transport contributes about 80% of the PM2.5 variation during the night. Reducing traffic emissions in Delhi alone (e.g. by 50 %) would reduce PM2.5 by 15 %–20 % but lead to a 20 %–25 % increase in O3. However, we show that reducing NCR regional emissions by 25 %–30 % at the same time would further reduce PM2.5 by 5 %–10 % in Delhi and avoid the O3 increase. This study provides scientific evidence to support the need for joint coordination of controls on local and regional scales to achieve effective reduction in PM2.5 whilst minimising the risk of O3 increase in Delhi.
8 November 2014 in Geoscientific Model Development
We have made a number of developments to the Weather, Research and Forecasting model coupled with Chemistry (WRF-Chem), with the aim of improving model prediction of trace atmospheric gas-phase chemical and aerosol composition, and of interactions between air quality and weather. A reduced form of the Common Reactive Intermediates gas-phase chemical mechanism (CRIv2-R5) has been added, using the Kinetic Pre-Processor (KPP) interface, to enable more explicit simulation of VOC degradation. N2O5 heterogeneous chemistry has been added to the existing sectional MOSAIC aerosol module, and coupled to both the CRIv2-R5 and existing CBM-Z gas-phase schemes. Modifications have also been made to the sea-spray aerosol emission representation, allowing the inclusion of primary organic material in sea-spray aerosol. We have worked on the European domain, with a particular focus on making the model suitable for the study of nighttime chemistry and oxidation by the nitrate radical in the UK atmosphere. Driven by appropriate emissions, wind fields and chemical boundary conditions, implementation of the different developments are illustrated, using a modified version of WRF-Chem 3.4.1, in order to demonstrate the impact that these changes have in the Northwest European domain. These developments are publicly available in WRF-Chem from version 3.5.1 onwards.
4 May 2016 in Atmospheric Chemistry and Physics
The Weather Research and Forecasting model with Chemistry (WRF-Chem) has been used to simulate a region of Brazil heavily influenced by biomass burning. Nested simulations were run at 5 and 1 km horizontal grid spacing for three case studies in September 2012. Simulations were run with and without fire emissions, convective parameterisation on the 5 km domain, and aerosol–radiation interactions in order to explore the differences attributable to the parameterisations and to better understand the aerosol direct effects and cloud responses. Direct aerosol–radiation interactions due to biomass burning aerosol resulted in a net cooling, with an average short-wave direct effect of −4.08 ± 1.53 Wm−2. However, around 21.7 Wm−2 is absorbed by aerosol in the atmospheric column, warming the atmosphere at the aerosol layer height, stabilising the column, inhibiting convection, and reducing cloud cover and precipitation. The changes to clouds due to radiatively absorbing aerosol (traditionally known as the semi-direct effects) increase the net short-wave radiation reaching the surface by reducing cloud cover, producing a secondary warming that counters the direct cooling. However, the magnitude of the semi-direct effect was found to be extremely sensitive to the model resolution and the use of convective parameterisation. Precipitation became organised in isolated convective cells when not using a convective parameterisation on the 5 km domain, reducing both total cloud cover and total precipitation. The SW semi-direct effect varied from 6.06 ± 1.46 with convective parameterisation to 3.61 ± 0.86 Wm−2 without. Convective cells within the 1 km domain are typically smaller but with greater updraft velocity than equivalent cells in the 5 km domain, reducing the proportion of the domain covered by cloud in all scenarios and producing a smaller semi-direct effect. Biomass burning (BB) aerosol particles acted as cloud condensation nuclei (CCN), increasing the droplet number concentration of clouds. However, the changes to cloud properties had negligible impact on the net radiative balance in either domain, with or without convective parameterisation. The sensitivity to the uncertainties relating to the semi-direct effect was greater than any other observable indirect effects. Although the version of WRF-Chem distributed to the community currently lacks aerosol–cloud interactions in parameterised clouds, the results of this study suggest a greater priority for the development is to improve the modelling of semi-direct effects by reducing the uncertainties relating to the use of convective parameterisation and resolution before WRF-Chem can reliably quantify the regional impacts of aerosols.
22 September 2020 in Atmospheric Chemistry and Physics
We present here results from a new mechanism, CRI-HOM, which we have developed to simulate the formation of highly oxygenated organic molecules (HOMs) from the gas-phase oxidation of α-pinene, one of the most widely emitted biogenic volatile organic compounds (BVOCs) by mass. This concise scheme adds 12 species and 66 reactions to the Common Representative Intermediates (CRI) mechanism v2.2 Reduction 5 and enables the representation of semi-explicit HOM treatment suitable for long-term global chemistry–aerosol–climate modelling, within a comprehensive tropospheric chemical mechanism. The key features of the new mechanism are (i) representation of the autoxidation of peroxy radicals from the hydroxyl radical and ozone initiated reactions of α-pinene, (ii) formation of multiple generations of peroxy radicals, (iii) formation of accretion products (dimers), and (iv) isoprene-driven suppression of accretion product formation, as observed in experiments. The mechanism has been constructed through optimisation against a series of flow tube laboratory experiments. The mechanism predicts a HOM yield of 2 %–4.5 % under conditions of low to moderate NOx, in line with experimental observations, and reproduces qualitatively the decline in HOM yield and concentration at higher NOx levels. The mechanism gives a HOM yield that also increases with temperature, in line with observations, and our mechanism compares favourably to some of the limited observations of [HOM] observed in the boreal forest in Finland and in the southeast USA. The reproduction of isoprene-driven suppression of HOMs is a key step forward as it enables global climate models to capture the interaction between the major BVOC species, along with the potential climatic feedbacks. This suppression is demonstrated when the mechanism is used to simulate atmospheric profiles over the boreal forest and rainforest; different isoprene concentrations result in different [HOM] distributions, illustrating the importance of BVOC interactions in atmospheric composition and climate. Finally particle nucleation rates calculated from [HOM] in present-day and pre-industrial atmospheres suggest that “sulfuric-acid-free” nucleation can compete effectively with other nucleation pathways in the boreal forest, particularly in the pre-industrial period, with important implications for the aerosol budget and radiative forcing.