Natural fibres find their way into many engineering applications in the automobile and aerospace sectors owing to their eco-friendly nature. Natural fiber produced from agricultural residue, is capable of enhancing the mechanical and thermal properties of composite materials while lowering their overall cost. The main aim of the current study is to investigate such natural fiber, nonwoven fabric reinforced composites. In this work, samples reinforced by non-woven Abutilon indicum (AI) fibre are manufactured with varying fibre weight percentages, such as 20%, 25%, 30%, 35%, 40%, using the hand layup method and needle-punching process to make the fabric and composite. Mechanical tests such as tensile, flexural, and compressive tests were using a universal testing machine, and impact tests were performed using an izod impact tester, in addition to morphological and thermal studies were performed on the above composites and their respect compositions. The effect of the fibres on FTIR and TGA was also investigated. In order to understand the bonding behaviors and the fractured composite specimens were examined by a scanning electron microscope (SEM). The findings revealed that the highest values of tensile and flexural strength were observed to be 39.796 MPa and 62.329 MPa at 35 wt% fibre and maximum impact strength and compressive strength were 0.441 joules and 47.45 Mpa at 35 wt% fibre.
Composites of epoxy resin reinforced with goat and human hair were obtained and subjected to cryogenic processing for 24 hours at temperature 77 K. Morphological (SEM), mechanical and thermogravimetric analyses (TGA) were performed. The best properties were obtained by using a reinforcement consisting of 60 wt% human hair and 40 wt% goat hair. The SEM confirmed good interactions at the interface for this composite.
1 January 2026 in Chemical Industry and Chemical Engineering Quarterly
This experimental research assessed the impacts of sensible and latent heat materials such as SAE 20W/40 (used engine oil, UEO), candelilla wax (CLW), and rice bran wax (RBW) in an ETSAH (Evacuated Tube Solar Air Heater). Four distinct arrangements were studied: one without a thermal energy storage material (TESM), one with a sensible heat material (SHM), and two with latent heat materials (LHM), to enable comparative analysis. The maximum outlet temperature of air for ETC filled with UEO was 108?C, for CLW 115?C, and RBW 133?C ? all measured at 13:00. However, without filling the TESM in the ETC, the outlet temperature was only 70?C. The maximum temperature difference of the air in the RBW material-filled ETSAH system was 94?C, whereas, without TESM, the temperature was only 31?C at 13:00. The maximum efficiency of the ETSAH system was achieved when using RBW as a PCM rather than both CLW and UEO-filled TESM. Moreover, the efficiency of the system increases around 1.7?1.8 times when the velocity of air increases from 1.5 to 2.5 m/s.