The photovoltaic technologies have been developed year by year in different countries; however, there are some countries where this kind of energy is being born, such as the Brazilian case. In this paper, some important parameters are analysed and applied to different solar cell materials, identifying that if the fossil fuels were substituted by solar cells, it would reduce the CO2 emissions by 93.2%. In addition, it is shown that the efficiency of solar cells is not as farther as it could be thought from coal thermoelectrical plants in Brazil and the cost of energy using solar cells could be as good as these thermoelectrical plants. Finally, the potentiality of Brazilian territory to implant this technology is presented, identifying that with the use of 0.2% of the territory, the energy demand could be supplied.
1 January 2019 in Rudarsko-geološko-naftni zbornik
Penobscot Field is located in the Sable Sub-basin in Nova Scotia, Canada, where a 3D seismic acquisition campaign was carried out in 1991 and also two oil wells were previously drilled (L-30 and B-41). In the interpreted seismic data, a discrepancy was found in the travel times of the seismic waves near well B-41, causing a false structural height in the Naskapi Member, Mississauga Formation (Early Cretaceous or Lower Cretaceous) and deeper formations (10 to 15 ms, i.e. approximately 25 m). It was decided to find a solution of this problem using synthetic models. First, making a delimitation of the study area by means of a seismic subcube, which were later interpreted surfaces of interest, through the well data. The average velocity and density properties were found for each interpreted strata. Subsequently, a 2D seismic acquisition was simulated, choosing a line that crossed both wells and through the use of ray traces, synthetic shot gathers were obtained and processed through the use of different seismic migration tests, and the final solution was found to be Kirchhoff pre-stacking migration in depth.
The world energy demand has become higher with the growing population, which has translated into an increase in emission of greenhouse gases into the atmosphere. For this reason, CO2 capture and storage has been undertaken to purify the atmosphere. For storing this CO2, it is necessary to have wells to inject it (deeper than 800 m); moreover, these wells need to have stability over time, and one of the stability aspects is the protection of steel against corrosion. Considering this aspect, the most common steels (focussed on American Petroleum Institute [API] steels) that can be used in an injector well were studied. The best performance was obtained using a high alloy content of Cr and Ni. Furthermore, the most important parameter analysed when corrosion is studied is the test time, which was modelled to stabilise the corrosion rates. The experiments were undertaken after a general review of different studies that investigated the corrosion of steel when in contact with CO2 in the vapour phase and under supercritical conditions.
27 March 2021 in Geotechnical and Geological Engineering
Penobscot Field is located in the Sable Sub-basin, in the Nova Scotia Basin, belonging to the Canadian territory, and for the year of 1991, a 3D seismic acquisition was carried out in this region. Also, two exploratory wells were previously drilled (L-30 and B-41). Then, with the subsequent interpretation of the area, a discrepancy was found around 10ms to 15ms (approximately 25m) in the travel times of the seismic waves in the vicinity of well B-41, resulting in a false structural high in the Mississauga Formation and Naskapi Member. It is possibly caused by changes in geological facies and thickness of the Wyandot formation, consequently, B-41 well became dry. For these reasons, to identify the possible problem which caused everything mentioned above, the area between the wells was delimited by a seismic subvolume (by reducing the seismic cube), making a seismic interpretation of the top of the formations of interest, as well as an analysis of certain petrophysical properties in the wells, in order to delimit the thickness of the anomaly and, consecutively, the use of the seismic attributes for lateral identification of the anomaly in the Wyandot Formation.