25 August 2015 in Nanoscale
This study characterizes the effects of incident infrared (IR) radiation on the electrical conductivity of graphene oxide (GO) and examines its potential for mid-IR detection. Analysis of the mildly reduced GO (m-GO) transport mechanism near room temperature reveals variable range hopping (VRH) for the conduction of electrons. This VRH behavior causes the m-GO resistance to exhibit a strong temperature dependence, with a large negative temperature coefficient of resistance of approximately −2 to −4% K−1. In addition to this hopping transport, the presence of various oxygen-related functional groups within GO enhances the absorption of IR radiation significantly. These two GO material properties are synergically coupled and provoke a remarkable photothermal effect within this material; specifically, a large resistance drop is exhibited by m-GO in response to the increase in temperature caused by the IR absorption. The m-GO bolometer effect identified in this study is different from that exhibited in vanadium oxides, which require added gold-black films that function as IR absorbers owing to their limited IR absorption capability.
8 June 2015 in Scientific Reports
We introduce a high-performance molecular sensor using self-corrugated chemically modified graphene as a three dimensional (3D) structure that indicates anisotropic charge distribution. This is capable of room-temperature operation, and, in particular, exhibiting high sensitivity and reversible fast response with equilibrium region. The morphology consists of periodic, “cratered” arrays that can be formed by condensation and evaporation of graphene oxide (GO) solution on interdigitated electrodes. Subsequent hydrazine reduction, the corrugated edge area of the graphene layers have a high electric potential compared with flat graphene films. This local accumulation of electrons interacts with a large number of gas molecules. The sensitivity of 3D-graphene sensors significantly increases in the atmosphere of NO2 gas. The intriguing structures have several advantages for straightforward fabrication on patterned substrates, high-performance graphene sensors without post-annealing process.
27 November 2022 in Carbon
15 July 2025 in Energy & Environmental Materials
Carbon coatings for silicon (Si)‐based anode materials are essential for designing high‐performance Li‐ion batteries (LIBs). The coatings prevent direct contact with the electrolyte and enhance anode performance. However, conventional carbon coatings are limited by their volume expansion and structural degradation, which lead to capacity fading and reduced durability. This study introduces a scalable and practical one‐step carbon‐coating strategy for directly coating silicon suboxide (SiO x )‐based materials using aqueous quasi‐defect‐free reduced graphene oxide (QrGO) without post‐treatment, unlike conventional graphene oxide (GO)‐based coating methods. This simple process enables uniform encapsulation with QrGO for a highly adhesive and conductive coating. The QrGO‐based composite anode material has several advantages, including reduced cracking due to volume expansion and enhanced charge carrier transport, as well as an increased Si content of 20 wt.% compared to the 5 wt.% in typical commercial Si‐based active materials. In particular, the capacity retention of the QrGO‐coated Si electrodes dramatically increases at high C‐rate. The full cell exhibited long‐term stability and capacity that were twice that of commercial SiO x ‐based cells. Therefore, the QrGO‐based one‐step coating process represents a scalable, transformative, and commercially viable strategy for developing high‐performance LIBs.