In this paper a new combined method for design of robust controller proposed for minimum phase systems. In order to design of controller, a new method which is combination of feedback linearization method and sliding mode technique was used. The used method is improved system robustness against uncertainties and disturbances. The proposed control scheme is simulated on a quadruple tank process to observe it's performance. There is a robust controller for controlling the height of the fluid level within tanks. There is also a nonlinear disturbance observer, in order to estimate uncertainties exerted to system. This observer was combined with designed controller to decrease the effects of the estimated uncertainties. The simulation results demonstrate that performance of the proposed method is notably promoted in comparison with other controllers presented for quadruple tank process.
The simultaneous localization and mapping (SLAM) is a main problem in navigation of autonomous robots and solving it is interesting for researchers. Nowadays the SLAM technique is one of key part the navigation systems. In this paper, an efficient inertia SLAM algorithm has been presented for an unmanned aerial vehicle (UAV) or any airborne vehicle. The structure of mentioned inertial SLAM algorithm is appropriate for application in both the Range/Bearing and Bearing-only inertial sensors. This algorithm is independent of any external positioning information such as global positioning system (GPS) or any prepared data of terrain sensors. This work proposes a perfect system that improves the efficiency and accuracy of 3D inertial SLAM and over comes two main problems that less consideration is available about them in previous researches. First, it considers all of freedom degrees such as altitude, the latitude and longitude for UAV. Second, the algorithm based on inertial sensors is able to observe all of landmarks in various heights. Finally, using real flight data, the proposed algorithm is tested and the results showed desired performance of the algorithm for inertial system.
In this paper, a restricted structure of PID controller is proposed for automobile gas turbine by considering a LQG cost function. So PID Controller coefficients are calculated by minimizing this cost function. One of the most important characteristics of this approach, its ability to design various structure PID controllers by solving optimization problem only for one time, moreover it can approximate main optimization problem by a repetitive Quadratic optimization Problem (QP). This approach is convex optimization and has an analytic solution; therefore its calculations are not complicated. In defined cost function, there are two weighting functions, control error and control action; they are adjusted to meet economical (control action) and operational (control error) requirement. Moreover, using restricted structure control criterions prepare appropriate conditions for designer. Restricted structure controller based on LQG, has proper low frequency gain and limited output variance. At first, appropriate input and output for gas turbine system is chosen and pre compensator is designed for decoupling of loops. After that mentioned controller is designed and applied. Simulation results indicate desired performance of gas turbine closed loop system with designed controller.