26 March 2019 in International Journal of Optics
A method with high detection rate, low false-alarm rate, and low computational cost is presented for removing stars and noise and detecting space debris with signal-to-noise ratio (SNR>3) in consecutive raw frames. The top-hat transformation is implemented firstly to remove background, then a masking technique is proposed to remove stars, and finally, a weighted algorithm is used to detect the pieces of space debris. The simulation samples are images taken by 600 mm ground-based telescope. And a series of simulation targets are added to the image in order to test the detection rate and false-alarm rate of different SNRs. The telescope in this paper is worked in “staring target mode.” The experimental results show that the proposed method can detect space debris effectively with low false-alarm by only three frames. When the SNR is higher than 3, the detection probability can reach 94%, and the false-alarm rate is below 2%. The running time of this algorithm is within 1 second. Additionally, algorithm performance tests in different regions are also carried out. A large set of image sequences are tested, which proves the stableness and effectiveness of the proposed method.
2 June 2019 in International Journal of Optics
We present an image processing algorithm based on edge extension to correct the influence of atmospheric dispersion. The Elden model is used to estimate the image dispersion index caused by atmospheric dispersion and the image affected by the atmospheric dispersion is regarded as the results of the original image convolution operation. When the direct convolution is used to compensate the blur of star, border effect and ill-posed problem make the result unacceptable. To solve these problems, we use image preprocessing and perform an edge extension method for images before the convolution. The simulated analysis and experimental results from a 300 mm telescope system show that the proposed method can effectively correct the influence of atmospheric dispersion even under relatively low signal to noise ratio (SNR<2). Compared with the traditional prism correction and fiber correction methods, this technique can greatly reduce the complexity of the optical system.