An ultracompact broadside and backfire pattern reconfigurable Huygens dipole antenna (HDA) is developed that achieves a quasi-isotropic and uniformly-polarized radiation pattern. A novel reconfiguration scheme is adopted that only switches the phase of the electric dipole by 180° in an electrically small Huygens (complementary) source antenna. Its magnetic dipole is left unchanged. The system is realized by an Egyptian axe dipole (EAD), a reconfigurable capacitively-loaded loop (CLL) with one PIN diode, a reconfigurable short driven-dipole with one PIN diode, one capacitor, four DC biasing lines, and four RF chokes. The antenna radiates a broadside Huygens pattern when all the diodes are off. By turning on the diode in the middle of the additional thin strip below the top strip of the CLL, a 180° phase alteration will be obtained and a backfire Huygens pattern is realized. To achieve an overlapped operating band for the two pattern modes, the diode in the short driven-dipole is turned on to extend its length to compensate for the ensuing impedance mismatch. Measured results confirm the simulations. The antenna is attractive for wireless applications that require compact antennas with large radiation coverage and uniform polarization.
7 July 2023 in IEEE Transactions on Antennas and Propagation
A novel ultracompact four-arm electrically small omnidirectional circularly polarized (OCP) helical antenna is reported that consists of a half-wavelength normal-mode helical antenna as the driven element and three parasitic helical arms. With the introduction of the three properly arranged parasitic arms besides the driven element, the in-phased current density is largely strengthened and thus the radiation resistance of the multi-arm helical antenna is substantially enlarged from 3.3 Ohms (driven-element only) to 45 Ohms. Good impedance matching with standard transmission line becomes feasible. The entire volume of the design is only π (0.05 λ 0 ) 2 × 0.06 λ 0 ( ka < 0.39). It exhibits excellent OCP radiation performance with the Axial Ratio (AR) and gain variations less than 0.5 dB and 0.3 dB in 360° in the azimuth plane. Thanks to its ultracompact size, the single element is feasible to be expanded into a compact and highly-efficient collinear dual-OCP (DOCP) array with higher directivity and dual-CP functionality. A four-element prototype was demonstrated. Measurement shows the array achieves the peak realized gain (RG) values of 7.55 and 7.26 dBic for RHCP and LHCP, respectively. The overlapped impedance and AR bandwidth covers 0.98-1.02 GHz with isolation greater than 25 dB between the two polarizations.
18 March 2025 in IEEE Transactions on Antennas and Propagation
A novel electrically small shared-radiator Huygens dual-circularly-polarized (HDCP) antenna is developed that features an ultracompact size, i.e., π (0.12 λc)2 × 0.06 λc = 0.0027 λc3 (ka = 0.78) at 915 MHz. A shared-radiator is formed by a pair of orthogonally placed Huygens linearly-polarized (HLP) antennas. HDCP beams, i.e., left-hand CP (LHCP) and right-hand CP (RHCP) Huygens beams, can be simultaneously excited by an ‘8’-shaped feed-line as the driven element. To compensate for the inductive impedance, an innovative and compact LC matching network is developed to match both ports to standard 50 Ω transmission lines. The measured results of the prototype agree reasonably with the simulated ones. The results showcase a good isolation lower than -16 dB between the two input ports and a wide measured (simulated) 3-dB AR beamwidth of 120° (144°). Additionally, the measured peak realized gain values for LHCP and RHCP beams are consistent, e.g., 2.8 dBic and 2.6 dBic, respectively. As an ultracompact DCP antenna, it is an ideal candidate for wireless applications that require DCP performance along with compact system size, e.g., battery-free IoT ecosystems with simultaneous wireless power and data transmission.
16 January 2026 in IEEE Internet of Things Journal
Wireless power transfer (WPT) technology holds the key to unlock the massive deployment of wirelessly powered battery-free IoT devices and has become an emerging topic in IoT applications. As IoT devices are distributed randomly in the environment, antennas featuring broad circularly polarized (CP) radiation coverage are highly promising as a power source to wirelessly charge them. Herein, in this article, an electrically small pattern reconfigurable Huygens CP antenna with quasi-isotropic beam coverage is presented for WPT enabled IoT applications. It consists of a pair of orthogonally placed crossed Egyptian axe dipoles (EADs), customized reconfigurable capacitively loaded loops (CLLs), and an unbalanced reconfigurable crossed driven-dipole structure. Pattern reconfigurability is realized due to the phase reversal of the EADs by switching the diodes at the center of the additional crossed shorter strips beneath the upper section of the CLLs. Furthermore, to ensure overlapping bandwidths for impedance matching and AR, the effective lengths of the driven-dipole arms are reconfigurable by controlling the diodes. An optimized prototype was fabricated and validated, showing a peak realized gain of 2.45 dBic and a wide 3-dB AR beamwidth of larger than 100° for both modes in an electrically small size (ka=0.79).
5 January 2026 in IEEE Journal on Wireless Power Technologies
This paper introduces an efficient and dual-mode approach to wirelessly charge supercapacitors, as DC power suppliers for IoT devices, via Huygens rectenna. A novel voltage-dependent S-parameter analysis method is developed to maximize the far-field wireless power transfer (WPT) efficiency in supercapacitor-loaded Huygens rectenna systems. Thanks to the high-Q feature of Huygens rectenna, two charging modes, i.e., rapid and float, are realized by simply switching the operating frequency. Moreover, an innovative deep learning-assisted modeling method for supercapacitor is developed to accurately predict the charging time under different input RF powers. Operating within the 915MHz ISM band (902 to 928 MHz), the entire rectenna system is electrically small with the size of ka = 0.98. Experiment results show the highest average charging efficiency of 50.4% in the rapid charging mode at 904 MHz. Moreover, the frequency switching charging approach eliminates the need for additional charging management circuitry and effectively prevents the overcharging of supercapacitor under float mode. The developed method is further validated through a practical IoT sensor system. The system charges a 0.1 F supercapacitor in 433.2 seconds from 10 dBm input power, enabling over 3,400 seconds of operation. Experiment results demonstrate its viability for sustainable and continuous power supply.
1 January 2025 in IET Microwaves, Antennas & Propagation
This paper introduces a novel compact planar end‐fire antenna system featuring circularly polarised (CP) radiation and zero ground clearance. The system is constructed using a half‐wavelength TE 0.5,0 mode open waveguide, which inherently generates vertically polarised electric components. By incorporating a slow‐wave (SW) structure in the form of metallised blind via holes within the waveguide, a significant SW effect is achieved, resulting in a 40% reduction in the waveguide longitudinal size compared to the conventional counterpart design. Furthermore, by etching an open‐ended slot in the top metallic surface of the waveguide, the edges of its aperture are enabled to generate an electric dipole mode. In this way, the horizontally polarised electric components can be achieved without increasing the antenna's footprint. With the proper combination, the design can effectively achieve the required 90°‐phase difference in the end‐fire direction for these two components. Finally, a 2.5 GHz antenna was designed and optimised. Aiming to mimic the practical environment of mobile terminal devices, a large metallic ground was adopted under the antenna in the simulation and experiment. The measured results indicated that an overlapped impedance |S 11 | < −10 and axial ratio (AR < 3) bandwidth of 2.7% from 2.495 to 2.562 GHz is achieved. The proposed antenna shows great potential in wireless communication applications for mobile terminal devices.