Jonathan C. Matti

Jonathan C. Matti

Auto-generated profile, based on publicly available information

Jonathan C. Matti

U.S. Geological Survey, 520 North Park Avenue, Tucson, Arizona 85719, USA

Research Focus & Metrics

Academic Career Length

45Years (1982-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2022
Verified
Report
Closed access
PDF file
GCGeoffrey Cromwell
Geoffrey Cromwell
JMJonathan C. Matti
Jonathan C. Matti
The Yucaipa groundwater subbasin (referred to in this report as the Yucaipa subbasin) is located about 75 miles (mi) east of of Los Angeles and about 12 mi southeast of the City of San Bernardino. In the Yucaipa subbasin, as in much of southern California, limited annual rainfall and large water demands can strain existing water supplies; therefore, understanding local surface water and groundwater conditions is essential for managing these resources. To better understand the hydrogeology and water resources in the Yucaipa subbasin, especially groundwater, the San Bernardino Valley Municipal Water District and the U.S. Geological Survey initiated a cooperative study to evaluate the hydrogeologic system of the Yucaipa subbasin and the encompassing Yucaipa Valley watershed. Previous studies of the area provided information on general geologic and hydrologic conditions, but this study provides the first comprehensive definition of the hydrogeology of the subsurface throughout the entire subbasin.The Yucaipa subbasin is located between the northwest trending San Andreas fault zone and San Jacinto fault. Several northeast-trending dip-slip faults dissect the Yucaipa subbasin, providing the mechanism for structural relief within the sediment-filled subbasin and between the subbasin and surrounding mountains and highlands. Several of these dip-slip faults have been previously identified as potential barriers to groundwater flow. This report provides a synthesis of previous studies and a discussion of the geologic interpretations that were used as the foundation for hydrogeologic classification of the Yucaipa subbasin. Notably, this report (1) adopts the recently named and classified sedimentary deposits of Live Oak Canyon geologic formation and extends the mapped distribution of the formation into the Yucaipa subbasin, and (2) adopts the interpretation that activity along the Banning fault predates the deposition of most basin-fill sedimentary materials in the Yucaipa subbasin.Four hydrogeologic units were classified in the Yucaipa subbasin: (1) crystalline basement, (2) consolidated sedimentary materials, (3) unconsolidated sediment, and (4) surficial materials. The crystalline basement unit forms the bottom boundary of the aquifer system, and the three other units comprise the basin-fill aquifer system. The four hydrogeologic units vary in extent, thickness, and structural relief across the subbasin, with the unconsolidated sediment unit serving as the primary aquifer unit. A three-dimensional hydrogeologic framework model was developed for the Yucaipa subbasin and surrounding area to characterize the thickness, extent, and hydrogeologic variability of the aquifer system. Geologic maps, borehole geophysical logs, drillers’ lithology logs, and depth-to-basement gravity data were used to map and interpolate the subsurface extent and structure of the hydrogeologic units within the subbasin. Faults and structures of geologic and (or) hydrogeologic importance were included in the model for future evaluation of their potential effects on groundwater flow. The resulting hydrogeologic framework is consistent with existing geologic concepts and the tectonic and structural history of the Yucaipa subbasin and surrounding area. The framework is also suitable for use in basin-scale hydrogeologic investigations.

1 January 2022
Verified
Report
Closed access
PDF file
CSChristina Stamos-Pfeiffer
Christina Stamos-Pfeiffer
JLJoshua D. Larsen
Joshua D. Larsen
RPRobert E. Powell
Robert E. Powell
JMJonathan C. Matti
Jonathan C. Matti
PMPeter Martin
Peter Martin
The Lucerne Valley is in the southwestern part of the Mojave Desert and is about 75 miles northeast of Los Angeles, California. The Lucerne Valley groundwater basin encompasses about 230 square miles and is separated from the Upper Mojave Valley groundwater basin by splays of the Helendale Fault. Since its settlement, groundwater has been the primary source of water for agricultural, industrial, municipal, and domestic uses. Groundwater withdrawal from pumping has exceeded the amount of water recharged to the basin, causing groundwater declines of more than 100 feet between 1917 and 2016 in the center of the basin. The continued withdrawal has resulted in an increase in pumping costs, reduced well efficiency, and land subsidence near Lucerne Lake. Although the volume of pumping has declined in recent years, there is concern that new agricultural growth and limits on imported water will continue to strain the sustainability of the groundwater system.To address these concerns, the U.S. Geological Survey entered into a cooperative agreement with the Mojave Water Agency to develop a better understanding of the Lucerne Valley hydrogeologic system and provide tools to help evaluate and manage the effects of future development in the Lucerne Valley. The objectives of this study were to (1) improve the understanding of the aquifer system, (2) improve the understanding of subsidence in the basin, and (3) incorporate the understanding into a groundwater-flow model that can be used to help manage the groundwater resources in the Lucerne Valley. The model developed for this study covers the period of 1942–2016 and can help evaluate various proposed water-management scenarios during different climatic and hydrologic conditions.The aquifer system consists of a shallow aquifer, a confining unit, and middle and lower aquifers. These layered water-bearing units were identified based on geologic units of the mostly unconsolidated sediments and hydrologic properties. These alluvial deposits consist of clay, silt, sand, and gravel; some places also contain clay and silty clay lacustrine deposits. Several faults act, at least in part, as barriers to groundwater flow on the eastern, southern, and western edges of the basin. Present-day natural recharge is primarily from the infiltration of runoff from the San Bernardino Mountains to the south; however, stable and radioactive isotopes show that groundwater from the middle of the Lucerne Valley was older than about 10,000 years and probably was recharged as infiltration from streams draining the mountains in the Mojave Desert to the north, which probably does not occur under present-day climatic conditions. The annual average natural recharge for 1942–2016, estimated by a Basin Characterization Model, was about 635 acre-feet per year; the average amount of treated wastewater effluent transferred to the Lucerne Valley for artificial recharge annually ranged from about 1,500 to 4,000 acre-feet per year during 1980–2016. Pumpage estimates for 1942–2016 ranged from about 3,000 acre-feet in 1942 to about 18,300 acre-feet in 1984. The total cumulative amount of groundwater removed from the basin by pumping between 1942 and 2016 was estimated to be about 700,000 acre-feet, which was about 10 times greater than the cumulative amount of recharge to the entire Lucerne Valley groundwater basin. Before groundwater development, the direction of groundwater flow was from the southern part of the basin northward to discharge areas near Lucerne Lake, where it discharged through springs along the Helendale Fault and by evapotranspiration. Since the early 1900s, groundwater-level declines have mostly eliminated the areas where natural discharge occurred and exceeded 100 feet in the middle of the basin between the early 1950s and mid-1990s, and as much as 25 feet near the margins from about the mid-1950s to 2000s. A decrease in the rate of pumping after the mid-1990s lessened the hydraulic stress on the middle and lower aquifers and enabled hydraulic heads in the middle of the basin to recover slightly as groundwater near the margins of the basin moved toward the pumping depression. Although trends in groundwater levels in the center of the basin have reversed since the mid-1990s, levels at the basin margins continue to decline as the movement of groundwater from the margins fills the pumping depression and gradually flattens the groundwater table throughout the basin.The long-term extraction of groundwater and associated dewatering of the fine-grained sediments present within the aquifer system has resulted in aquifer compaction and consequently land subsidence, primarily near Lucerne Lake. Analysis of interferometric synthetic aperture radar data shows that almost 11 inches of land subsidence has occurred south of Lucerne Lake between April 1992 and November 2009; less subsidence occurred elsewhere in the basin during this period. This differential land subsidence has caused fissures and cracks in the ground surface, which have buckled the pavement and undercut roads in several locations.The Lucerne Valley Hydrologic Model was developed using the finite-difference groundwater modeling software One Water Hydrologic Model to represent the hydrologic conditions and stresses during 1942–2016. The model has a uniform grid of approximately 92 acres per cell (2,000 feet by 2,000 feet) and has four layers representing the water-bearing units. The results from the calibrated model simulations indicated that groundwater pumpage exceeded recharge, resulting in an estimated net cumulative depletion of groundwater storage (discharge minus recharge) of about 465,000 acre-feet from 1942 to 2016. The model simulated as much as 7.5 feet (90 inches; 2,286 millimeters) of aquifer compaction, which indicates the extensive fine-grained deposits and measured subsidence near Lucerne Lake.

18 February 2022 in Geosphere
Verified
Journal Article
Open access
PDF file
KKKatherine J. Kendrick
Katherine J. Kendrick
JMJonathan C. Matti
Jonathan C. Matti
NBNicolas C. Barth
Nicolas C. Barth
The San Gorgonio Pass region of southern California is a locus of extensive Quaternary deformation within a multi-strand section of the San Andreas fault zone. The geomorphology of the San Gorgonio Pass region reflects the complicated history of geologic events in the formation of this structurally complex region. We define fault-bounded blocks in San Gorgonio Pass and focus on two that are characterized by extensive crystalline bedrock outcrops with similar bedrock lithologies. These two blocks are separated by the San Bernardino strand of the San Andreas fault. Morphometric variables, including local relief, slope, slope distribution, and surface roughness, consistently demonstrate distinctions between the bedrock upland regions of the two blocks. Geologic observations of the region highlight differences in Quaternary units within the two blocks, reflective of the differing surficial processes active in each block. Within the Kitching Peak block, the morphology highlights a lineament that we informally name the Lion Canyon lineament. This boundary more clearly differentiates the two regions, as compared to the mapped San Bernardino strand, and may represent the previously active strand or bounding structure in this section. The distinction in morphology and surficial processes leads to our interpretation that the Kitching Peak and Pisgah Peak blocks have experienced different uplift histories. This further leads to the conclusion that the San Bernardino strand, broadly defined, has been integrated, at some point in the past, with the Banning strand, allowing for through-going rupture along the fault system. This connectivity may have occurred along the Burro Flats section of the San Bernardino strand or the Lion Canyon lineament. The fault connection along the mapped trace of the San Bernardino strand is not currently evident at the surface, however, suggesting that the integration has been disrupted. We propose this is due to intervals of N-S compression in the region, manifest as slip along the San Gorgonio Pass fault zone and other regional faults. We present evidence for lateral displacement along the San Bernardino and Banning strands of the San Andreas fault, discuss the implications of these displacements, and propose a sequence of fault activity, including multiple phases of activity along the San Bernardino and Banning strand pathway to account for the structural complexity and lack of surficial fault continuity.


1 January 1982
Verified
Report
Closed access
JMJonathan C. Matti
Jonathan C. Matti
BCBrett F. Cox
Brett F. Cox
EREduardo A. Rodriguez
Eduardo A. Rodriguez
COCurtis M. Obi
Curtis M. Obi
RPRobert E. Powell
Robert E. Powell
GCGary J. Cwick
Gary J. Cwick

1 January 1983
Verified
Report
Open access
PDF file
RPRobert E. Powell
Robert E. Powell
JMJonathan C. Matti
Jonathan C. Matti
BCBrett F. Cox
Brett F. Cox
HOHoward W. Oliver
Howard W. Oliver
AWAlexander Wagini
Alexander Wagini
HCHarry W. Campbell
Harry W. Campbell
Geologic, geochemical, and geophysical investigations and a survey of mines and prospects indicate that the Sugaloaf Roadless Area contains subeconomic graphite and magnesian marble resources. Parts of the area have a low potential for the occurrence of additional low-grade graphite resources, but there is no potential for additional magnesian marble resources within the roadless area. Sand, gravel, and construction stone other than carbonate rocks are found in the roadless area, but similar or better quality materials are abundant and more accessible outside the area. The roadless area has no identified energy mineral resources, but parts of the area have a low to moderate potential for low-grade uranium resources. There are no identified metallic mineral resources within the area, and there is no evidence of a potential for the occurrence of such resources. No previously unknown mineral occurrence was located during this study.