1 August 2018 in Physics of Plasmas
Hot spots induced by lower hybrid wave in experimental advanced superconducting tokamak tokamak have caused high performance experiment disruption and serious damages to the guard limiters. Experimental and theoretical analyses have been carried out to study its physical mechanism. Plasma density scan experiments indicate that the wall temperature within the hot spots enhanced by a factor of 5 and increases with the plasma density near the antenna. A lower hybrid current drive (LHCD)-only density climb experiment shows that the carbon impurity decreases to a minimum value at certain plasma density and then increases with the line averaged plasma density. A model has been developed to explain the mechanism of sputtering of graphite tiles due to hot spots as the plasma density near the LHCD antenna and the time increases. A theoretical scaling of the heat flux driven by LHCD is also presented and is consistent with the experimental scaling in the Tore Supra tokamak. The simulation results show that the total sputtering flux density has a minimum at a certain plasma density and gradually increases as the plasma density increases or decreases away from the minimum value, and the increase in parallel heat flux near the antenna would enhance the sputtering flux density. The sputtering flux density trend is qualitatively consistent with the density scan experiments. The simulated temporal evolution of sputtered flux implies that the chemical sputtering could be a candidate for the carbon impurity explosion.
1 July 2018 in Physics of Plasmas
In this paper, we will experimentally investigate the power threshold (PL-H) in upper single null plasmas with an ITER-like tungsten divertor under different ∇B drift directions on EAST [F. Ding et al., Commissioning and PSI Behavior of the ITER-Like W/Cu Divertor in EAST 22nd PSI, Rome (2016)]. The power threshold for the low (L) to high (H) confinement mode has a clear and positive toroidal magnetic field, BT, dependence when the ∇B drift points toward the primary X-point (B×∇B↑). A factor of 2–3 increase in PL-H is observed for the ∇B drift away from the primary X-point (B×∇B↓). The edge and core impurities quantified by spectroscopy measurements show comparable levels for the transitions for both drift directions. On the other hand, it is found that the divertor Dα emission just prior to the L-H transition is lower for B×∇B↑, compared with that for B×∇B↓. The upper in-out divertor asymmetry, as manifested by particle fluxes measured by the divertor triple Langmuir probe, is most marked for B×∇B↓, and with significantly more particle flux to the outer divertor. The reversing field increases the particle flux into the upper inner and lower outer divertor, reducing the in-out asymmetry. One important distinction between the two field directions has been observed, with respect to the amplitude of the scrape-off layer (SOL) parallel flow. A dedicated experiment under similar target plasma conditions shows a lower SOL density and thus a steeper density gradient slightly inside the separatrix, where a lower PL-H is found for the B×∇B↑, compared to that for B×∇B↓. We, therefore, conclude that the field-dependent SOL plasma conditions play an important role in the transition physics.
17 September 2019 in Nuclear Fusion
1 August 2020 in Fusion Engineering and Design
1 December 2018 in Fusion Engineering and Design