9 November 2015 in IEEE Communications Magazine
We review and discuss the challenges of adopting software-defined radio principles in underwater acoustic networks, and propose a software-defined acoustic modem prototype based on commercial off-the-shelf components. We first review current SDR-based architectures for underwater acoustic communications. Then we describe the architecture of a new software-defined acoustic modem prototype, and provide performance evaluation results in both indoor (water tank) and outdoor (lake) environments. We present three experimental testbed scenarios that demonstrate the real-time reconfigurable capabilities of the proposed prototype and show that it exhibits favorable characteristics toward spectrally efficient cognitive underwater networks, and high data rate underwater acoustic links. Finally, we discuss open research challenges for the implementation of next-generation software-defined underwater acoustic networks.
12 March 2018 in IEEE Access
There is an emerging need for high-rate underwater acoustic (UW-A) communication platforms to enable a new generation of underwater monitoring applications including video streaming. At the same time, modern UW-A communication architectures need to be flexible to adapt and optimize their communication parameters in real time based on the environmental conditions. Existing UW-A modems are limited in terms of achievable data rates and ability to adapt the protocol stack in real time. To overcome this limitation, we present the design, implementation, and experimental evaluation of a new high-rate software-defined acoustic modem (SDAM) with real-time adaptation capabilities for UW-A communications. We introduce new physical-layer adaptation mechanisms that enable either joint adaptation of communication parameters such as modulation constellation and channel coding rate or seamless switching between different communication technologies such as orthogonal-frequency-division-multiplexing and direct-sequence-spread-spectrum. The performance of the proposed SDAM has been evaluated in both indoor (water tank) and outdoor (lake) environments. We demonstrated that the SDAM achieves 104 kbit/s with bit-error-rate (BER) of 2 × 10 -5 , 208 kbit/s with BER of 10 -3 , and 260 kbit/s with BER of 10 -2 in real time over a 200 m horizontal link at a very-shallow lake environment.
8 October 2020 in IEEE Transactions on Mobile Computing
The Internet of Underwater Things (IoUT) will enable new military, scientific, and commercial applications at sea. However, powering of electronic devices in deep water still remains one of the main challenges, since these systems are typically powered by traditional batteries. This article presents the design of the first batteryless underwater sensor node that can be wirelessly recharged through ultrasonic waves from longer distances than allowed by current technologies. First, the architecture of an underwater platform capable of extracting electrical energy from ultrasonic waves is introduced. We then illustrate how to interface this system with an underwater digital communication unit. We discuss the design of a prototype where the storage unit is realized with a batch of supercapacitors. We show through experiments that the harvested energy is sufficient to provide the sensor node with the power necessary to perform a sensing operation and power a modem for ultrasonic communications. In the article, we evaluate the system power transfer efficiency. Given the reduced attenuation of ultrasonic waves in water, we show that our approach can cover longer distances with less transmission power than alternative solutions. Last, we experimentally evaluate the overall operating efficiency of the system.