The preparation and performance adjustment of low-dielectric polyimide (PI) play important roles in the development and application of next-generation dielectric materials used in high-speed integrated circuits. Herein, composite polyimide films with sandwich-type porous structures were fabricated via a microemulsion method, in which the self-assembly of water droplets was involved. Decreases in the dielectric constant and water absorption and increases in the tensile strength and tensile modulus were simultaneously realized due to the presence of symmetrical porous structures and a dense PI layer upon the introduction of the sandwich-type porous structure. The dielectric, mechanical and water resistance properties of the composite PI films could be further regulated by controlling the porous structure using different conditions for film formation. By varying the temperature, humidity, concentrations of polymer and surfactant in the microemulsion method, we obtained the low dielectric constants of 2.24–2.81 and the low water absorptions of 0.49–0.59%, with decreases from 15.73% to 32.81% and 76.02% to 80.08%, respectively, as compared to the case of the flat PI film; we also achieved the high tensile strengths of 97.7–103.2 MPa and high tensile moduli of 1.2–1.4 GPa, with the increases of 4.83–10.73% and 6.57–16.43%, respectively, as compared to the case of the flat PI film. Moreover, excellent durability of the low dielectric constant under high humidity condition was demonstrated by the very small increase in the dielectric constant (0.02–1%) in a moist environment. These results provide useful information for the structural design of high-performance dielectric materials.
Developing multifunctional hydrogels with stretchability, self-healing ability, adhesiveness, and conductivity into flexible strain sensors for human motion and health monitoring has attracted great attention and is highly desired. However, the present motion detectors mainly focus on stretching, bending, and twisting of different body parts while the expansion–contraction motion has been rarely investigated. In this study, along with carbon nanotubes (CNTs) as conductive components, sodium alginate (Alg) modified with 3-aminophenylboronic acid (PBA) and dopamine (DA) were synthesized and employed as precursors to prepare a multifunctional Alg-CNT hydrogel. The formed dynamic covalent bonds between PBA and DA endowed the hydrogel with a rapid self-healing property (30 s) while the introduction of CNTs remarkably enhanced the mechanical strength and electrical conductivity of the hydrogel. Moreover, the as-prepared hydrogel displayed a satisfactory stretchability (500%) and self-adhesiveness to various substrates. When used as a strain sensor, the Alg-CNT hydrogel that exhibited a fast response (150 ms) and ultra-durability (over 30 000 cycles) was demonstrated to be capable of monitoring subtle expansion–contraction motions (e.g., human breathing and mouse heart beating) via periodic and repeatable electrical signals. Therefore, this multifunctional hydrogel is highly suitable for monitoring expansion–contraction motions, indicating its potential applications in personal health monitoring.
1 November 2020 in Colloids and Surfaces B: Biointerfaces