1 February 2013 in Canadian Geotechnical Journal
The resilient modulus, MR, of subgrade soil is an important stiffness parameter for analysing fatigue cracking in either the asphalt or concrete layer of a pavement. Although subgrade soil is often unsaturated and subject to seasonal variations of moisture content and hence suction in the field, effects of soil suction on the resilient modulus are generally not accounted for in existing testing methods. In this study, MRvalues of a subgrade soil under various stress and suction conditions were investigated using a suction-controlled cyclic triaxial apparatus. To enhance the accuracy of measurements, Hall-effect transducers were employed to monitor the local axial and radial deformation of each specimen. It was found that MRincreases with number of load applications when a soil contracts, but decreases slightly when a soil dilates. When suction increases, the soil response tends to change from contractive to dilative due to suction-induced dilatancy. Moreover, the measured MRis highly dependent on the stress state. It decreases with cyclic stress due to the nonlinearity of the soil stress–strain behaviour, but increases significantly with suction due to the presence of water tension. At the same stress and suction conditions, MRmeasured along the wetting path is generally larger than that measured along the drying path. A new semi-empirical equation representing the stress-dependency of MRis proposed and was verified using experimental results of four different soils.
1 September 2016 in Géotechnique
Plant evapotranspiration is recognised to affect soil suction of slopes and landfill covers. Previous work has focused on evapotranspiration-induced suction by a single plant, with little attention paid to the effects of planting density. The aim of this study is to quantify any changes in tree growth and tree-induced suction during evapotranspiration and rainfall under different planting densities for non-mixed-species plantations. A tree species, Schefflera heptaphylla, which is commonly found in Asia, was planted in silty sand at spacings of 60, 120 and 180 mm, representing three different planting densities. For each case, three replicates were tested to consider tree variability. In total, the responses of suction for 297 seedlings subjected to drying and a rainfall event with a 10-year return period were measured. The test results show that reducing the tree spacing from 180 to 60 mm induced greater tree–tree competition for water, as indicated by a 364% increase in peak suction upon evapotranspiration. Such tree–tree interaction led to: (a) a 19–35% reduction in the leaf area index; (b) a 17–36% decrease in root length; and (c) an obvious decay of roots. Upon the rainfall event, the infiltration rate for vegetated soil with trees planted at a spacing of 60 mm was up to 247% higher than those for soil with a wider tree spacing, where mainly fresh roots were found. Although most suction within the root zone (i.e. top 100 mm) was lost due to increased infiltration at 60 mm spacing, suctions in deeper depths below root zone were largely preserved.
1 October 2014 in Computers and Geotechnics
1 July 2014 in Géotechnique
Subgrade soils are constantly subjected to daily variations of temperature and suction in the field. Their deformation under cyclic traffic loads can greatly affect the performance of a pavement. Yet, the behaviour of unsaturated subgrade soils under cyclic loads at various temperatures and suctions is not fully understood. In this study, a new suction- and temperature-controlled cyclic triaxial apparatus was developed. Using temperature-compensated Hall effect transducers, the accumulated plastic axial and volumetric strains and resilient modulus of an unsaturated silt under cyclic loads were measured at suctions ranging from 0 to 60 kPa and temperatures ranging from 20 to 60°C. Experimental results show that yield stress increases with increasing suction (suction-induced hardening), but decreases with increasing temperature (thermal-induced softening). Consequently, axial plastic strain accumulated during cyclic loading–unloading is larger at lower suctions and higher temperatures. At a given temperature, measured resilient modulus significantly increases when suction increases. On the other hand, the influence of temperature on resilient modulus depends on suction level. At zero suction, resilient modulus is slightly affected by temperature. At suction larger than zero, an increase in temperature induces an obvious decrease in resilient modulus. It is evident that thermal effects on resilient modulus are more significant at unsaturated than saturated states.
2 July 2020 in Acta Geotechnica
1 June 2016 in Géotechnique Letters
The volume changes of saturated sand under heating and cooling cycles can greatly affect the serviceability of many earth structures in geo-energy and geo-environmental engineering. Up to date, this aspect of thermo-mechanical soil behaviour has not been fully understood. In this study, a temperature-controlled triaxial apparatus was developed to investigate the thermally induced volume changes of soil skeleton of saturated Toyoura sand. Soil specimens with different initial densities were isotopically compressed and then subjected to two thermal cycles in the temperature range of 23 to 50°C. During the first heating process, loose and medium dense specimens showed contractive strains of approximately 0·15% and 0·05% respectively as the temperature rose from 23 to 35°C. The observed contraction is most probably because the thermal expansion of soil particles adjusted force chains inside the specimen, inducing plastic contraction and soil hardening. Both specimens showed dilative strain of approximately 0·05% as the temperature increased further from 35 to 50°C. On the contrary, for the dense specimen with a more stable structure, only dilation was observed during heating with a volumetric strain of approximately 0·1%. During the second thermal cycle, the responses of sand specimens with different densities were almost reversible with heating dilation and cooling contraction.