Pavel V. Fursikov

Pavel V. Fursikov

Auto-generated profile, based on publicly available information

Pavel V. Fursikov

Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2018 in Russian Chemical Bulletin
Verified
Journal Article
Closed access
PDF file
PFP. V. Fursikov
P. V. Fursikov
BTB. P. Tarasov
B. P. Tarasov

1 January 2011 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
DBDmitry N. Borisov
Dmitry N. Borisov
PFPavel V. Fursikov
Pavel V. Fursikov
BTBoris P. Tarasov
Boris P. Tarasov

6 July 2023 in Inorganics
Verified
Journal Article
Open access
PDF file
BTBoris Tarasov
Boris Tarasov
AAArtem Arbuzov
Artem Arbuzov
SMSergey Mozhzhukhin
Sergey Mozhzhukhin
AVAleksey Volodin
Aleksey Volodin
PFPavel Fursikov
Pavel Fursikov
MLMykhaylo Lototskyy
Mykhaylo Lototskyy
Metal hydride (MH) hydrogen storage and compression systems with near-atmospheric H2 suction pressure are necessary for the utilization of the low-pressure H2 produced by solid oxide electrolyzers or released as a byproduct of chemical industries. Such systems should provide reasonably high productivity in the modes of both charge (H2 absorption at PL ≤ 1 atm) and discharge (H2 desorption at PH = 2–5 atm), which implies the provision of H2 equilibrium pressures Peq < PL at the available cooling temperature (TL = 15–20 °C) and, at the same time, Peq > PH when heated to TH = 90–150 °C. This work presents results of the development of such systems based on AB5-type intermetallics characterized by Peq of 0.1–0.3 atm and 3–8 atm for H2 absorption at TL = 15 °C and H2 desorption at TH = 100 °C, respectively. The MH powders mixed with 1 wt.% of Ni-doped graphene-like material or expanded natural graphite for the improvement of H2 charge dynamics were loaded in a cylindrical container equipped with internal and external heat exchangers. The developed units with a capacity of about 1 Nm3 H2 were shown to exhibit H2 flow rates above 10 NL/min during H2 charge at ≤1 atm when cooled to ≤20 °C with cold water and H2 release at a pressure above 2 and 5 atm when heated to 90 and 120 °C with hot water and steam, respectively.

7 May 2020 in Russian Journal of Physical Chemistry A
Verified
Journal Article
Closed access
PDF file
PFP. V. Fursikov
P. V. Fursikov
ASA. M. Sleptsova
A. M. Sleptsova
SMS. A. Mozhzhukhin
S. A. Mozhzhukhin
AAA. A. Arbuzov
A. A. Arbuzov
VFV. N. Fokin
V. N. Fokin
BTB. P. Tarasov
B. P. Tarasov
Powder composites of hydrogenated eutectic Mg–Ni alloy with 10 wt % graphene-like material (GLM) were prepared mechanochemically at a hydrogen pressure of 30 atm. The effect that adding GLM, along with 10 cycles of desorption at 350°C and 1 atm and sorption at 300°C and 10 atm of hydrogen, has on the phase composition and microstructure of the composites is studied. It is shown that composites obtained mechanochemically (hbm composites) and subjected to cycles of hydrogen desorption–adsorption (dh composites) contain crystalline phases: α-MgH2 with rutile-type structure, Mg2NiH4 hydride with a disordered cubic structure (pseudo-ht-Mg2NiH4), and a solid solution of hydrogen Mg2NiH≤0.3. It is found that in hbm composites with GLM additives, the content of the pseudo-ht-Mg2Ni phase is higher than in composites without carbon additives. The Mg2Ni(H) and Mg(H) particles have a common boundary in composites, and cycling does not affect these features of the microstructure. The presence of GLM preserves the small particle sizes of both phases during cycling.

1 September 2011 in Russian Chemical Bulletin
Verified
Journal Article
Closed access
PDF file
PFP. V. Fursikov
P. V. Fursikov
DBD. N. Borisov
D. N. Borisov
BTB. P. Tarasov
B. P. Tarasov

1 August 2022 in Russian Journal of Applied Chemistry
Verified
Journal Article
Closed access
PDF file
PFP. V. Fursikov
P. V. Fursikov
VFV. N. Fokin
V. N. Fokin
EFE. E. Fokina
E. E. Fokina
SMS. A. Mozhzhukhin
S. A. Mozhzhukhin
AAA. A. Arbuzov
A. A. Arbuzov
BTB. P. Tarasov
B. P. Tarasov
Using transmission electron microscopy (TEM) and electron microdiffraction with the radiolysis effect and a series of calibration images of TEM obtained for single-phase MgH2 samples at different exposure times, we studied the topological features of the microstructure of powder hydrogen-sorbing composites based on the Mg89Ni11 eutectic alloy. It was found that after several hydrogenation–dehydrogenation cycles the composite retains a highly dispersed microstructure: in the regions of composite samples with a cross-sectional area of 1 μm2 there are grains of Mg and Mg2Ni hydride-forming phases that are in direct contact, which improves the hydrogen-sorbing characteristics of the composite.