Selda Erkoc-Ilter

Selda Erkoc-Ilter

Auto-generated profile, based on publicly available information

Selda Erkoc-Ilter

Integrated Manufacturing Technologies Research and Application Center & Composite Technologies Center of Excellence, Sabancı University, İstanbul, Turkiye

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2019 in Separation and Purification Technology
Verified
Journal Article
Closed access
JSJalal-Al-Din Sharabati
Jalal-Al-Din Sharabati
SGSerkan Guclu
Serkan Guclu
SESelda Erkoc-Ilter
Selda Erkoc-Ilter
Derya Y. Koseoglu-ImerDerya Y. Koseoglu-Imer
Derya Y. Koseoglu-Imer
SÜSerkan Ünal
Serkan Ünal
IKIsmail Koyuncu
Ismail Koyuncu

1 September 2019 in Progress in Organic Coatings
Verified
Journal Article
Closed access
FSFarzin Saffarimiandoab
Farzin Saffarimiandoab
BGBahar Yavuzturk Gul
Bahar Yavuzturk Gul
SESelda Erkoc-Ilter
Selda Erkoc-Ilter
SGSerkan Guclu
Serkan Guclu
SÜSerkan Ünal
Serkan Ünal
IKIsmail Koyuncu
Ismail Koyuncu

18 August 2025 in TURKISH JOURNAL OF CHEMISTRY
Verified
Journal Article
Open access
PDF file
SISelda Erkoç İlTer
Selda Erkoç İlTer
A synthesized zwitterionic monohydroxyl monomer (ZHM) was used as an additive to incorporate zwitterionic sulfobetaine groups into the polyamide (PA) active layers of thin-film composite membranes. Incorporation of ZHM into the PA active layers was achieved through interfacial polymerization, involving the introduction of ZHM and m-phenylenediamine (MPD) into the aqueous phase, and the addition of trimesoyl chloride (TMC) to the hexane phase. The surfaces of the resulting reverse osmosis (RO) membranes were subjected to characterization through water contact angle (WCA) and field emission scanning electron microscopy (FESEM) analyses. The successful incorporation of ZHM into the active PA layers was confirmed by X-ray photoelectron spectroscopy (XPS) and Fourier transform infrared spectroscopy (FTIR) analysis. To assess the flux and salt rejection performance of the fabricated membranes, aqueous solutions containing 2000 ppm NaCl or MgSO4 were filtered in a dead-end filtration system under a pressure of 15 bar. Compared to the control membrane (ZHM-0), the ZHM-modified membranes had significantly enhanced flux without compromising salt retention. In the NaCl solution filtration, the modified membrane (ZHM-1) increased in flux from 6.8 to 9.1 L/m2h while having similar salt rejection (approximately 91%) in comparison to the control membrane (ZHM-0). In the MgSO4 solution filtration, the modified membranes increased in flux from 6.7 to 9.5 L/m2h, while maintaining a consistent salt rejection rate of 100%, mirroring that of the control membrane.