1 January 2016 in Mathematical Problems in Engineering
The minimum miscibility pressure (MMP) determines the main mechanism of CO2flooding, which is either an immiscible or miscible process. This paper examines the recovery improvements of CO2flooding in terms of both the injection temperature and solvent composition. The results show that a lower temperature injection and LPG (liquefied petroleum gas) mixture can considerably improve oil recovery due to the reduced MMP in the swept area caused by the injected solvent. For the pure CO2injection at the reservoir temperature, oil recovery is 59% after 1.0 PV CO2injection. The oil recoveries by CO2-LPG mixtures are improved to 73% with 0.1 mole fractions of LPG and 81% with 0.2 mole fractions of LPG. The recovery factor from low-temperature CO2injection is 78%, which is 32% higher compared to the isothermal case. The recoveries obtained by low-temperature CO2-LPG injection increase up to 87% of the initial oil. Heat transfer between the reservoir and the formation of over/underburden should be considered in order to describe the process more accurately. Additionally, the recovery factors from the heat transfer models are decreased by 4–12% in comparison with the original nonisothermal models.
9 June 2020 in Energy Exploration & Exploitation
This study proposes economic evaluation of CO2 geological storage with enhanced oil recovery. The procedures consider capital expenditures and operating costs of infrastructures and revenues from oil recovery and carbon tax credits. Extensive CO2 geological storage with enhanced oil recovery simulations was conducted to determine the most promising scenario among cases, where miscibility was controlled by the addition of liquefied petroleum gas. The addition of liquefied petroleum gas into a CO2 injection stream can accelerate reduction of oil viscosity, interfacial tension, and oil density, which cause improved displacement efficiency. The larger was the amount of liquefied petroleum gas injected, the greater was the miscibility due to minimum miscibility pressure reduction, resulting in higher oil recovery and less CO2 sequestration. Although liquefied petroleum gas addition enhances the performance of CO2 enhanced oil recovery, economic analysis should be conducted for CO2 geological storage with enhanced oil recovery due to the higher price of liquefied petroleum gas than that of CO2. Net present value decreased from liquefied petroleum gas mole fraction of 0–2% and started to increase from mole fraction 2–13% due to the miscibility effect. Then, net present value started to decrease, because the purchasing and injecting prices of the required liquefied petroleum gas exceeded that of the oil produced. Economic evaluation showed that addition of 13% liquefied petroleum gas was the most promising scenario, with a net present value of 91 MM$. Thus, we confirmed an optimum liquefied petroleum gas concentration in the CO2 geological storage with enhanced oil recovery process.
1 January 2015 in Journal of Chemistry
The addition of LPG to the CO 2 stream leads to minimum miscible pressure (MMP) reduction that causes more oil swelling and interfacial tension reduction compared to CO 2 EOR, resulting in improved oil recovery. Numerical study based on compositional simulation has been performed to examine the injectivity efficiency and transport behavior of water‐alternating CO 2 ‐LPG EOR. Based on oil, CO 2 , and LPG prices, optimum LPG concentration and composition were designed for different wettability conditions. Results from this study indicate how injected LPG mole fraction and butane content in LPG affect lowering of interfacial tension. Interfacial tension reduction by supplement of LPG components leads to miscible condition causing more enhanced oil recovery. The maximum enhancement of oil recovery for oil‐wet reservoir is 50% which is greater than 22% for water‐wet reservoir. According to the result of net present value (NPV) analysis at designated oil, CO 2 , propane, and butane prices, the optimal injected LPG mole fraction and composition exist for maximum NPV. At the case of maximum NPV for oil‐wet reservoir, the LPG fraction is about 25% in which compositions of propane and butane are 37% and 63%, respectively. For water‐wet reservoir, the LPG fraction is 20% and compositions of propane and butane are 0% and 100%.