The wind is one of the most promising green energy resources that replenishes itselves in less than a human lifetime without depleting the planet’s resources. According to the disposition of the blade concerning the shaft, wind turbine can be classified as horizontal axis wind turbine (HAWT) and vertical axis wind turbine (VAWT). In contrast to VAWT, HAWT covers most commercial installations around the globe. However, VAWTs became a promising alternative for areas far away from grid-connected electricity, they have certain drawbacks associated with aerodynamic performance. The present work overviews the magnitude of factors affecting the aerodynamics of typical VAWT, i.e H-Darrieus VAWT and enhancement options associated with cutting edge performance. Additionally, the accuracy of the turbine performance predicting tools through computational investigation and optimization was also assessed. Therefore, the review covered the factors that altered the turbine performance and viable enhancement options studied in the existing literature. Finally, FSI simulation was tics of materials commonly used for turbine blade manufacturing. It was determined that the computational tools employed significantly influence the accuracy of the model, and proper model selection and more experimental validations are compulsory. It was determined that the computational tools employed significantly influence the accuracy of the model, and proper model selection and more experimental validations are compulsory.
Solar photovoltaic (PV) systems are commonly used for sustainable energy generation, even in regions with limited land availability and high temperatures. Using computational fluid dynamics (CFD) this study evaluates the performance of a solar PV system under variable solar insolation and wind conditions, which affect their efficiency. A particular feature of the simulation is to determine the distribution of cell temperature over the module as module efficiency decreases with increasing temperature and variable temperature reduces output by causing mismatches in the maximum efficiency point of the individual cells. Thus, the simulation solves the energy equation for the air temperature and no convective heat transfer coefficients are used. Steady‐state simulations are shown to analyze the effects of wind speeds ranging from 1 to 10 m/s on the drag coefficient Cd , lift coefficient Cl , and temperature distribution of the PV modules. The CFD results are validated against experimental data from recent studies. The findings indicates that increasing wind speed enhances convective cooling and significantly reduces PV module temperature, with the strongest cooling effect occurring at low‐to‐moderate wind speeds under solar irradiance levels of 700–1000 W/m 2 and ambient temperature of 25°C at a 15° tilt angle. At low wind speeds, hotspots form on the module surface, resulting in higher operational temperatures and potential performance degradation. In contrast, at higher wind speeds, more uniform cooling is observed, lowering the maximum module temperature from 60°C at 1 m/s to 35°C at 10 m/s, in contrast, higher wind speeds promoted more uniform cooling and improved thermal stability across the module. Although the aerodynamic forces acting on the module increase with wind speed, the force coefficients may decrease. This research demonstrates that CFD can be used for optimizing the design and positioning of PV systems in regions with moderate to high wind speeds.