Three-dimensional (3D) bioprinting demonstrates significant potential for advancing regenerative medicine through precise fabrication of functional tissue constructs via controlled deposition of cells, biomaterials, and bioactive factors. However, balancing key parameters-printing efficiency, resolution, and cell viability-remains challenging for replicating native tissue complexity. This review comprehensively examines recent advancements in three prominent bioprinting modalities: inkjet, extrusion-based, and digital light processing (DLP). Analysis reveals inherent performance trade-offs among these technologies. Inkjet bioprinting achieves high resolution (10-80 μm) at moderate speeds but exhibits limited cell viability (74-85%). Extrusion-based methods enable higher fabrication rates (0.00785-62.83 mm³/s) with variable viability (40-90%) at reduced resolution (100-2000 μm). DLP offers superior efficiency (0.648-840 mm³/s) and ultra-high resolution (2-50 μm) with favorable viability (75-95%), although limitations persist regarding photoinitiator toxicity and light penetration depth. Critical examination identifies energy-induced cell damage as a significant factor, with shear stress and UV exposure representing key detrimental influences. Bioink properties also emerge as crucial determinants of printing outcomes. The review further integrates modeling approaches for extrusion-based bioprinting and discusses preliminary computational modeling attempts. Future directions should focus on developing low-viscosity cell-compatible bioinks, advancing hybrid printing strategies, and establishing predictive models to harmonize printing parameters with biological outcomes. Interdisciplinary collaboration remains essential to fully realize the clinical potential of bioprinted tissues and organoids.
Aqueous nanolubricants containing ZrO2 nanoparticles, graphene oxide (GO) nanosheets, or hybrid nanoparticles of ZrO2 and GO were formulated using a cost-effective ultrasonication de-agglomeration method. The friction and wear characteristics of these water-based nanolubricants were systematically investigated using a block-on-ring testing configuration with a stainless- and alloy steel contact pair. The concentrations and mass ratios of nanoadditives were varied from 0.02 to 0.10 wt.% and 1:5 to 5:1, respectively, to obtain optimal lubrication performance. The application of a 0.06 wt.% 1:1 ZrO2/GO hybrid nanolubricant resulted in a 57% reduction in COF and a 77% decrease in wear volume compared to water. The optimised ZrO2/GO hybrid nanolubricant was found to perform better than pure ZrO2 and GO nanolubricant in terms of tribological performance due to its synergistic lubrication effect, which showed up to 54% and 41% reductions in friction as well as 42% and 20% decreases in wear compared with 0.06 wt.% ZrO2 and 0.06 wt.% GO nanolubricants. The analysis of wear scars revealed that using such a ZrO2/GO hybrid nanolubricant yielded a smooth worn surface, with 87%, 45%, and 33% reductions in Sa compared to water and 0.06 wt.% ZrO2 and 0.06 wt.% GO nanolubricants. The superior tribological performance can be ascribed to the combination of the rolling effect of ZrO2 nanoparticles and the slipping effect of GO nanosheets.