13 November 2020 in Nature Communications
Distributed optical fibre sensors deliver a map of a physical quantity along an optical fibre, providing a unique solution for health monitoring of targeted structures. Considerable developments over recent years have pushed conventional distributed sensors towards their ultimate performance, while any significant improvement demands a substantial hardware overhead. Here, a technique is proposed, encoding the interrogating light signal by a single-sequence aperiodic code and spatially resolving the fibre information through a fast post-processing. The code sequence is once forever computed by a specifically developed genetic algorithm, enabling a performance enhancement using an unmodified conventional configuration for the sensor. The proposed approach is experimentally demonstrated in Brillouin and Raman based sensors, both outperforming the state-of-the-art. This methodological breakthrough can be readily implemented in existing instruments by only modifying the software, offering a simple and cost-effective upgrade towards higher performance for distributed fibre sensing.
22 June 2020 in Optics Express
The signal-to-noise ratio (SNR) of Brillouin optical time-domain analyzers (BOTDA) is modelled and experimentally validated, using direct detection with and without the use of optical pre-amplification. The behavior of SNR as a function of the Brillouin gain and the probe power reaching the photo detection is analyzed in depth using this developed model and checked using two photodetectors with different specifications. It proves that a pre-amplification associated to a good-quality photodetector and a well-matched post-processing filtering can secure the highest SNR for direct-detection BOTDA. Such an optimal SNR presents only a 2.3 dB penalty compared to the ideal shot-noise-limited case that can only be reached using rather sophisticated configurations. In addition, the model here established predicts the SNR at any fiber position in any given experimental condition.
20 July 2020 in Optics Letters
A novel, to the best of our knowledge, postprocessing technique is proposed to extract with a flexible and variable spatial resolution the information from Brillouin optical time-domain analyzers, obtained using a pulse longer than the acoustic settling time. The negative impact of the acoustic transient effect is suppressed, enabling a Brillouin response proportional to the spatial resolution and a Brillouin gain spectrum keeping its natural linewidth. This leads to a better overall sensing performance, in particular for submetric spatial resolutions, with no compromises on sensing range and measurement time.
29 June 2021 in Optics Express
Noise models for both single-pulse and coded Brillouin optical time-domain analyzers (BOTDA) are established to quantify the actual signal-to-noise ratio (SNR) enhancement provided by pulse coding at any fiber position and in any operating condition. Simulation and experimental results show that the polarization noise and spontaneous Brillouin scattering (SpBS) to signal beating noise could highly penalize the performance of coded-BOTDA, depending on the code type and the interrogated fiber position. The models also serve as a useful tool to optimize the SNR improvement by trading off the accumulated Brillouin gain and optical noises.
24 April 2019 in Optics Express
When studying the spatial resolution and Brillouin frequency shift (BFS) uncertainty in Brillouin optical time domain analysis (BOTDA) system with a hotspot, people usually focuses on the point with best performance in the hotspot and neglect the huge error around it. The error is caused by the Brillouin gain spectrum (BGS) contributed by both the hotspot and the ambient segment, which is distorted from standard Lorentzian curve. Due to the distortion of BGS, the estimated BFS near the hotspot is shifted from the actual value and results in BFS error along the fiber. The distorted BGS can be double-peak or single-peak curve that is dependent on both the length of the hotspot that contributes to BGS and the BFS difference between the hotspot and the ambient segment. A fitting technique considering the combined contributions of hotspot and ambient segment is proposed to recover the distorted BGS near the hotspot and evaluate BFS. It is demonstrated that BFS error around hotspot is greatly reduced compare to the conventional Lorentzian fitting and dual Lorentzian fitting schemes.