1 January 2024 in Physics of Fluids
In experimental studies, single-wave mode and two counter-rotating wave mode are often observed in rotating detonation combustors. To investigate the mechanism behind different propagation modes, high-resolution numerical simulations of two-dimensional detonation in hydrogen/air mixtures are conducted by solving the reactive Navier–Stokes equations with a detailed chemical mechanism. The numerical results show that the occurrence of the dual-wave detonation propagation mode is positively influenced by an increase in both the channel width and the initial pressure. The dual-wave modes are observed when increasing the channel width, and it is found that the dual-wave modes are caused by increasing the residual premixed gas height near the inner wall. When increasing the initial pressure, the initial peak detonation heat release increases, which leads to the increase in the hot spot intensity formed, and it is found that the dual-wave modes are mainly caused by the interactions between the initial detonation wave and the inner wall. However, the initial equivalent ratio appears to have a relatively minor impact on the detonation propagation mode due to a relatively narrow range variation of physical properties. The peak heat release rate exerts a greater influence on the change of the propagation mode than the induction time does through a wider range test on rotating detonation engines' working condition. Moreover, the velocities and the cell sizes of detonation waves propagating in different directions with different channel widths are also analyzed, revealing that the characteristics of the detonation waves propagating in different directions are nearly the same.
1 August 2023 in Physics of Fluids
The study investigates the oblique detonation characteristics in a stoichiometric methane–air mixture employing reactive Euler equations coupled with a detailed chemical reaction model. The analysis evaluates the initiation variation for both the inflow Mach number and the wedge angle. The results show that an increase in the Mach number from M0 = 9 to M0 = 12 changes the oblique shock-to-detonation transition from an abrupt to a smooth type. Furthermore, the distinction between high and low Mach numbers is explored through a comparison of the induction length along the wave surface. Additionally, the transition is affected by changes in wedge angle elevation under high Mach numbers, while a large wedge angle generates a second detonation wave surface due to a strong reflection shock downstream under low Mach numbers. Finally, the initiation length is quantitatively compared across varying inflow Mach numbers and wedge angles, which can benefit future investigations of a methane-fueled oblique detonation engine.