1 December 2021 in Ocean Engineering
27 July 2023 in Applied Ocean Research
1 April 2015 in Polish Maritime Research
Ship hull structure elements are usually joined by welding. Welding distortions may cause many problems during manufacturing process. In the literature a wide spectrum of suggestions has been proposed for correct estimation of welding deformation, particularly angular ones, in the fillet welded T-joints. In this work a verification of certain methods selected from the literature is presented basing upon the results of the laboratory measurements. To this end, values determined on the basis of engineering hypotheses have been compared with those obtained from the laboratory tests.
20 December 2017 in Polish Maritime Research
The development and growing availability of modern technologies, along with more and more severe environment protection standards which frequently take a form of legal regulations, are the reason why attempts are made to find a quiet and economical propulsion system not only for newly built watercraft units, but also for modernised ones. Correct selection of the propulsion and supply system for a given vessel affects significantly not only the energy efficiency of the propulsions system but also the environment - as this selection is crucial for the noise and exhaust emission levels. The paper presents results of experimental examination of ship power demand performed on a historic passenger ship of 25 m in length. Two variants, referred to as serial and parallel hybrid propulsion systems, were examined with respect to the maximum length of the single-day route covered by the ship. The recorded power demands and environmental impact were compared with those characteristic for the already installed conventional propulsion system. Taking into account a high safety level expected to be ensured on a passenger ship, the serial hybrid system was based on two electric motors working in parallel and supplied from two separate sets of batteries. This solution ensures higher reliability, along with relatively high energy efficiency. The results of the performed examination have revealed that the serial propulsion system is the least harmful to the environment, but its investment cost is the highest. In this context, the optimum solution for the ship owner seems to be a parallel hybrid system of diesel-electric type
1 September 2013 in Polish Maritime Research
In the Faculty of Ocean Engineering and Ship Technology, Gdansk University of Technology, design has recently been developed of a small inland ship with hybrid propulsion and supply system. The ship will be propelled by a specially designed so called parallel hybrid propulsion system. The work was aimed at carrying out the energy efficiency analysis of a hybrid propulsion system operating in the electric motor drive mode and at performing the noise pollution measurements. The performed investigations have shown that a significant impact on the efficiency and on the acoustic emission has the type of belt transmission applied.
1 May 2021 in Engineering Structures