Considering the growing demand for piezoelectric energy harvesting from ferroelectric–polymer-based composite materials and the benefits associated with them, this work focuses on piezoelectric energy harvesting from poly(vinylidene fluoride)-co-hexafluoropropylene (PVDF-HFP)/BZT-BCT/GO hybrid composite films synthesized via solution casting followed by the hot-pressing method. Structural properties were analyzed using XRD, FTIR, and Raman spectroscopy. SEM micrographs confirmed the presence of pores in the synthesized samples that provided an added advantage toward enhancing its piezoelectricity. The dielectric and ferroelectric properties were studied, in which the dielectric constant increased up to 20.69, and the remnant polarization was found to be 0.0560 μC cm−2. A PUND analysis was performed to validate the data obtained from the static hysteresis loop. Piezoelectric charge and voltage coefficients were measured, which reach up to “−31 pC N−1” and “−252.5 mV m N−1,” respectively. Figure of merit, electromechanical coupling coefficient, and quality factor of the as-synthesized samples were calculated. A harvester prototype was fabricated to investigate the energy harvesting performance of the synthesized hybrid composite films. The highest open circuit voltage, short circuit current, and power density were recorded as 2.19 V, 24.17 nA, and 468.43 μ W m−2, respectively. The harvested energy can be utilized for powering low-power devices, showing the real-time applicability of the synthesized hybrid composite films.
The increasing global interest in sustainable, flexible, and self‐powered technologies has made piezoelectric energy harvesting from polymer‐based hybrid composites a core area of research. This work emphasizes on effect of the incorporation of exfoliated Molybdenum disulfide (MoS 2 ) to poly(vinylidene fluoride)‐co‐hexafluoropropylene/(0.5(BaZr 0.2 Ti 0.8 O 3 )‐0.5(Ba 0.7 Ca 0.3 TiO 3 )) (PVDF‐HFP/BZT‐BCT), thus making PVDF‐HFP/BZT‐BCT/MoS 2 hybrid composite films through solution casting and subsequent hot‐pressing process. Their structural, microstructural, dielectric, ferroelectric and piezoelectric properties were studied. β‐fraction of the hybrid composite films was determined to be greater than 65%. Relative permittivity of the hybrid composites increased up‐to 22.63, which is double than that of the pure PVDF‐HFP film. The piezoelectric constants and corresponding figure of merit were evaluated. Finite element simulations using COMSOL Multiphysics 6.0 were employed to predict the open‐circuit voltage (
V
OC ), which showed good agreement with experimental results obtained from the fabricated piezoelectric harvester prototype. Short‐circuit current (
I
SC ) and the corresponding power density (
P
D ) were also experimentally evaluated, demonstrating the practical viability of the hybrid composites for being utilized in self‐powered IoT devices, such as wearable health trackers, motion sensors, and air‐quality monitors.