This paper presents the design, fabrication, and experimental validation of a K-band reflector antenna using a triaxially woven carbonfiber-reinforced silicone (CFRS) composite for small satellite applications. The CFRS surface was formed by curing a single lamina sheet into a parabolic geometry to optimize electromagnetic performance and structural integrity. To mitigate reflection loss caused by fiber discontinuities at high frequencies, a sealed triaxial woven fabric was employed, improving surface continuity and isotropy. Waveguide-based S-parameter measurements yielded an equivalent electrical conductivity of approximately 3,686 S/m and a reflection loss of about 0.2 dB at 20 GHz. Surface profiling confirmed sub-millimeter surface accuracy, and gain degradation due to surface errors was estimated to be less than 0.1 dB. A 0.6 m parabolic reflector achieved a boresight gain of 37.4 dBi at 20 GHz, showing close agreement with full-wave simulations incorporating the measured material and geometric properties. While a conceptual umbrella-type structure was designed to assess mechanical feasibility, the experimental prototype was constructed with a fixed feed support to prioritize precise electromagnetic verification under ground-based conditions. This work provides an experimental foundation for the development of lightweight CFRS-based reflector antennas for future small satellites in low earth orbit.