11 February 2008 in Applied Physics Letters
The hollow pen method for writing thin films of materials from solution is utilized to deposit films of 6,13-bis(tri-isopropylsilylethynyl) pentacene (TIPS pentacene) onto SiO2 surfaces with pre-patterned source/drain gold contacts. We demonstrate that large domains are obtained for TIPS pentacene films deposited from 0.5–4.0wt% solutions with toluene. Crystalline grains with (001) orientation are observed to grow with sizes that can exceed 1mm along the writing direction. A preferred azimuthal orientation is also selected by the process, resulting in anisotropic field effect transistor mobility in the films.
17 April 2007 in Physical Review B
A study of ripple formation on sapphire surfaces by ion bombardment is presented. Surface characterization by in-situ synchrotron grazing incidence small angle x-ray scattering and ex-situ atomic force microscopy is performed in order to study the wavelength of ripples formed on sapphire (0001) surfaces. We find that the wavelength can be varied over a remarkably wide range—nearly two orders of magnitude—by changing the ion incidence angle. Within the linear theory regime, the ion induced viscous flow smoothing mechanism explains the general trends of the ripple wavelength at low temperature and incidence angles larger than . In this model, relaxation is confined to a few nm thick damaged surface layer. The behavior at high temperature suggests relaxation by surface diffusion. However, strong smoothing is inferred from the observed ripple wavelength near normal incidence, which is not consistent with either surface diffusion or viscous flow relaxation.
6 October 2008 in Physical Review B
We have investigated bombardment-induced pattern formation and smoothening during ion erosion of surfaces. The experiments show that ion smoothening of a patterned surface is explained by a mechanism where collisions with near-surface atoms produce an effective downhill current. Quantitative agreement is obtained using ion-collision simulations to compute the magnitude of the surface current. The results lead to predictions for the surface morphology phase diagram as a function of ion energy and incidence angle that substantially agree with experimental results.
1 January 2016 in APL Materials
We report an in situ microbeam grazing incidence X-ray scattering study of 2,7-dioctyl[1]benzothieno[3,2-b][1]benzothiophene (C8-BTBT) organic semiconductor thin film deposition by hollow pen writing. Multiple transient phases are observed during the crystallization for substrate temperatures up to ≈93 °C. The layered smectic liquid-crystalline phase of C8-BTBT initially forms and preceedes inter-layer ordering, followed by a transient crystalline phase for temperature >60 °C, and ultimately the stable phase. Based on these results, we demonstrate a method to produce extremely large grain size and high carrier mobility during high-speed processing. For high writing speed (25 mm/s), mobility up to 3.0 cm2/V-s has been observed.
22 October 1990 in Applied Physics Letters
Improved resolution of secondary‐ion mass spectrometry (SIMS) is obtained on Be δ‐doped GaAs grown by molecular beam epitaxy at a temperature of 500 °C. The measured impurity distribution width is 29 Å, which corresponds to a SIMS resolution of ΔzR=25 Å. Impurity diffusion lengths of ≤10 Å can be detected by the technique. The surface segregation of Si impurities in δ‐doped GaAs grown at 660 °C is investigated as a function of doping density. The segregation length increases with the Si density and is consistent with a segregation model based on the pinning of the Fermi level at the growing GaAs surface.
14 June 2019 in Nature Communications
The properties of artificially grown thin films are strongly affected by surface processes during growth. Coherent X-rays provide an approach to better understand such processes and fluctuations far from equilibrium. Here we report results for vacuum deposition of C60 on a graphene-coated surface investigated with X-ray Photon Correlation Spectroscopy in surface-sensitive conditions. Step-flow is observed through measurement of the step-edge velocity in the late stages of growth after crystalline mounds have formed. We show that the step-edge velocity is coupled to the terrace length, and that there is a variation in the velocity from larger step spacing at the center of crystalline mounds to closely-spaced, more slowly propagating steps at their edges. The results extend theories of surface growth, since the behavior is consistent with surface evolution driven by processes that include surface diffusion, the motion of step-edges, and attachment at step edges with significant step-edge barriers.