20 September 2017 in Journal of Applied Physics
Silver contacts to few-layer (5 to 14 layers thick) MoS2 have been studied before and after annealing. Annealing was found to be critical for reducing the contact resistance but did not degrade the operation of field-effect transistors that are part of the test structure. The contact resistance for the as-deposited samples was in the range of 0.8–3.5 kΩ μm. On the other hand, the contact resistance was reduced to 0.2–0.7 kΩ μm, evaluated at a constant sheet resistance of 32 kΩ/□, after annealing at 250 or 300 °C. The reduced contact resistance is attributed to diffusion of Ag into the MoS2 and doping, as supported by further electrical characterization of the contacts and devices.
6 June 2018 in Crystal Growth & Design
31 January 2017 in Journal of Vacuum Science & Technology B
Understanding oxidation of layered chalcogenide semiconductors is important for device processing, as oxidation can be both an intentional and unintentional result of processing steps. Here, the authors investigate chemical and morphological changes in mechanically exfoliated few-layer MoS2 in oxidizing and inert environments using different microscopies (optical, scanning electron, and atomic force) and spectroscopy (Raman, x-ray photoelectron, and Auger electron) techniques. The environments studied were oxygen, oxygen and water vapor, argon, argon and water vapor, and ultraviolet-generated ozone at temperatures from 25 to 550 °C. Oxidation at low temperatures resulted in the formation of a condensed molybdenum oxide phase and sulfur trioxide gas. At sufficiently elevated temperatures, all the products of oxidation volatilize, resulting in a vapor-phase etch. The kinetics of oxidation and etching depended upon the annealing gas, temperature, time, and the number of layers of MoS2. Conditions can be selected to create isolated etch pits, smooth oxide layers, oxide islands, or flakes of reduced lateral dimensions (etching from the flakes' edges). These results can provide useful guidance for MoS2 device processing.
18 August 2015 in Journal of Electronic Materials
19 September 2016 in Advanced Optical Materials
23 July 2013 in Journal of Applied Physics
Multilayer ohmic contacts with differing first metal layers (M = Mo, Pd, Pt) beneath a Ti/Pt diffusion barrier and Au cap were fabricated on and , and the relationship between their specific contact resistance and interfacial chemistry was examined. Palladium-based contacts offered the lowest specific contact resistances of and Ω-cm2 to - and , respectively. The low resistances of the Pd-based contact were correlated with the formation of a uniform PdxInGaAs phase in direct contact with InGaAs, as observed using transmission electron microscopy and energy dispersive spectroscopy. On the other hand, the Mo-based contact to and had much higher specific contact resistances, even though its specific contact resistance on lightly doped n-InGaAs was nearly the same as that of the Pd-based contact. The cause of this discrepancy was identified to be the native oxide layer that remained between the contact and semiconductor in the Mo-based contacts, as revealed using transmission electron microscopy, energy dispersive spectroscopy, and electron energy loss spectroscopy. The effect of the native oxide in series with the Schottky barrier is significant only when the contact is doped heavily enough that tunneling of carriers through the Schottky barrier introduces a very low resistance.