We introduce low-loss amorphous titanium dioxide (TiO2) strip waveguides with sub-wavelength dimensions. The waveguides were fabricated by the combination of atomic layer deposition (ALD), electron beam lithography (EBL), and reactive ion etching (RIE). Propagation losses of the strip waveguides were found to be as low as 5.0 dB/cm at 1.55 μm wavelength. Those propagation losses are mostly due to the sidewall roughness of the waveguides that is caused by the lithography process. The propagation losses were further reduced by deposition, on the fabricated strip waveguides, of an additional layer of TiO2 made by using ALD. A supplementary layer of TiO2 with a thickness of 30 nm reduced the measured propagation losses from 5.0 ± 0.5 dB/cm to 2.4 ± 0.2 dB/cm at 1.55 μm wavelength. It is due to the fact that, after the redeposition process, the initial waveguide sidewall, i.e., the TiO 2/air interface, is virtually removed and the new sidewall has a reduced roughness.
We present the first, to our knowledge, experimental demonstration of a titanium dioxide slot waveguide operating in the visible range of light. Ring resonators based on slot waveguides were designed, fabricated, and characterized for . The fabrication method includes atomic layer deposition, electron beam lithography, and reactive ion etching. The required narrow slot widths of a few tens of nanometers were achieved by using a conformal atomic layer re-coating technique. This unique feature-size-reduction technique was applied after the final etching step.
31 January 2018 in Journal of Lightwave Technology
As high aspect ratio ridges are not easy to process with standard lithographic techniques, we propose alternative solutions based on atomic layer deposition and precise dicing to allow both uniform coating of the relief surface and a selective lift-off at the top of the ridges. The techniques are successfully employed to demonstrate an electro-optical low-loss tapered ridge waveguide with 90 % of electro-optical overlap coefficient, and a Fabry-Perot-based 150 μm long intensity modulator with a figure of merit 8 times better than a standard Ti-indiffused electro-optical (EO) modulator. Further enhancement is expected by optimizing the manufacturing of the Fabry-Perot cavity inside the ridge. These developments open the way to active 3D microstructures, not only for optical applications but also for MEMS, acoustic or microfluidic devices.