11 October 2024 in Physical Review Applied
Quantum error correction enables the preservation of logical qubits with a lower logical error rate than the physical error rate, with performance depending on the decoding method. Traditional decoding approaches rely on the binarization (“hardening”) of readout data, thereby ignoring valuable information embedded in the analog (“soft”) readout signal. We present experimental results showcasing the advantages of incorporating soft information into the decoding process of a distance-3 ( d = 3 ) bit-flip surface code with flux-tunable transmons. We encode each of the 16 computational states that make up the logical state | 0 L ⟩ , and protect them against bit-flip errors by performing repeated Z -basis stabilizer measurements. To infer the logical fidelity for the | 0 L ⟩ state, we average across the 16 computational states and employ two decoding strategies: minimum-weight perfect matching and a recurrent neural network. Our results show a reduction of up to 6.8% in the extracted logical error rate with the use of soft information. Decoding with soft information is widely applicable, independent of the physical qubit platform, and could allow for shorter readout durations, further minimizing logical error rates. Published by the American Physical Society 2024
1 June 2026 in Nature Communications
Quantum error correction will be essential for quantum computers to realise their full potential. As quantum computers advance towards demonstrating a universal fault-tolerant logical gate set, implementing scalable and low-latency real-time decoding will be crucial to avoid an exponential slowdown and maintain a fast logical clock rate. Here, we demonstrate low-latency feedback with a scalable FPGA decoder integrated into the control system of a superconducting quantum processor. We perform an 8-qubit stability experiment with up to 25 decoding rounds and a sub-microsecond mean decoding time per round, providing strong evidence that the backlog problem will be avoided when the decoder is operated as a streaming decoder on a superconducting hardware with the strictest speed requirements. We observe logical error suppression as the number of decoding rounds is increased. We also implement and time a fast-feedback experiment demonstrating a decoding response time of 9.6 μ s for a total of 9 measurement rounds.
17 March 2026 in Quantum Science and Technology
Imperfect measurements are a prevalent source of error across quantum computing platforms, significantly degrading the logical error rates achievable on current hardware. To mitigate this issue, rich measurement data referred to as soft information has been proposed to efficiently identify and correct measurement errors as they occur. In this work, we model soft information decoding across a variety of physical qubit platforms and decoders and showcase how soft information can make error correction viable at lower code distances and higher physical error rates than is otherwise possible. We simulate the effects of soft information decoding on quantum memories for surface codes and bivariate bicycle codes, and evaluate the error suppression performance of soft decoders against traditional decoders. Our simulations show that soft information decoding on near-term devices can provide up to 11% higher error suppression on superconducting qubits and up to 20% stronger error suppression on neutral atom qubits. These accuracy gains correspond to 13% and 33% reductions in the physical qubit footprint of superconducting and neutral atom devices respectively when operating at a logical error rate of 10 −6 , showcasing that soft information is a powerful tool for reducing the cost and complexity of large-scale fault-tolerant quantum computers.