Yanfeng Shen

Yanfeng Shen

Auto-generated profile, based on publicly available information

Yanfeng Shen

Danfoss Silicon Power R&D Munich, Ismaning, Germany

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 August 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
MFMojtaba Forouzesh
Mojtaba Forouzesh
YSYanfeng Shen
Yanfeng Shen
KYKeyvan Yari
Keyvan Yari
Yam SiwakotiYam Siwakoti
Yam Siwakoti
Frede BlaabjergFrede Blaabjerg
Frede Blaabjerg
This paper introduces a non-isolated high step-up dc-dc converter with dual coupled inductors suitable for distributed generation applications. By implementing an input parallel connection, the proposed dc-dc structure inherits shared input current with low ripple, which also requires small capacitive filter at its input. Moreover, this topology can reach high voltage gain by using dual coupled inductors in series connection at the output stage. The proposed converter uses active clamp circuits with a shared clamp capacitor for the main switches. In addition to the active clamp circuit, the leakage energy is recycled to the output by using an integrated regenerative snubber. Indeed, these circuits allow soft-switching conditions, i.e., zero voltage switching and zero current switching for active and passive switching devices, respectively. The mentioned features along with a common ground connection of the input and output make the proposed topology a proper candidate for transformer-less grid-connected photovoltaic systems. The operating performance, analysis and mathematical derivations of the proposed dc-dc converter have been demonstrated in the paper. Moreover, the main features of the proposed converter have been verified through experimental results of a 1-kW laboratory prototype.

16 September 2014 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XSXiaofeng Sun
Xiaofeng Sun
YSYanfeng Shen
Yanfeng Shen
YZYune Zhu
Yune Zhu
XGXiaoqiang Guo
Xiaoqiang Guo
This paper proposes a current-fed LLC resonant converter that is able to achieve high efficiency over a wide input voltage range. It is derived by integrating a two-phase interleaved boost circuit and a full-bridge LLC circuit together by virtue of sharing the same full-bridge switching unit. Compared with conventional full-bridge LLC converter, the gain characteristic is improved in terms of both gain range and optimal operation area, fixed-frequency pulsewidth-modulated (PWM) control is employed to achieve output voltage regulation, and the input current ripple is minimized as well. The voltage across the turned-off primary-side switch can be always clamped by the bus voltage, reducing the switch voltage stress. Besides, its other distinct features, such as single-stage configuration, and soft switching for all switches also contribute to high power conversion efficiency. The operation principles are presented, and then the main characteristics regarding gain, input current ripple, and zero-voltage switching (ZVS) considering the nonlinear output capacitance of MOSFET are investigated and compared with conventional solutions. Also, the design procedure for some key parameters is presented, and two kinds of interleaved boost integrated resonant converter topologies are generalized. Finally, experimental results of a converter prototype with 120-240 V input and 24 V/25 A output verify all considerations.

20 April 2015 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
XSXiaofeng Sun
Xiaofeng Sun
YSYanfeng Shen
Yanfeng Shen
WLWuying Li
Wuying Li
HWHongfei Wu
Hongfei Wu
A pulsewidth modulation (PWM) and pulse frequency modulation (PFM) hybrid modulated three-port converter (TPC) interfacing a photovoltaic (PV) source, a storage battery, and a load is proposed for a standalone PV/battery power system. The TPC is derived by integrating a two-phase interleaved boost circuit and a full-bridge LLC resonant circuit. Hence, it features a reduced number of switches, lower cost, and single-stage power conversion between any two of the three ports. With the PWM and PFM hybrid modulation strategy, the dc voltage gain from the PV to the load is wide, the input current ripple is small, and flexible power management among three ports can be easily achieved. Moreover, all primary switches turn ON with zero-voltage switching (ZVS), while all secondary diodes operate with zero-current switching over full operating range, which is beneficial for reducing switching losses, switch voltage stress, and electromagnetic interference. The topology derivation and power transfer analysis are presented. Depending on the resonant states, two different operation modes are identified and explored. Then, main characteristics, including the gain, input current ripple, and ZVS, are analyzed and compared. Furthermore, guidelines for parameter design and optimization are given as well. Finally, a 500-W laboratory prototype is built and tested to verify the effectiveness and advantages of all proposals.

29 August 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
ZQZian Qin
Zian Qin
YSYanfeng Shen
Yanfeng Shen
PLPoh Chiang Loh
Poh Chiang Loh
Huai WangHuai Wang
Huai Wang
Frede BlaabjergFrede Blaabjerg
Frede Blaabjerg
A Dual active bridge (DAB) converter can achieve a wide high-efficiency range when its input and output voltages are equal, assuming a 1:1 turns ratio for its isolation transformer. If its input or output voltage is doubled, efficiency of the DAB will drop significantly, because of the introduction of the hard switching and high circulating power. Thus, a new modulation scheme has been proposed, whose main idea is to introduce a voltage offset across the dc blocking capacitor connected in series with the transformer. Operational principle of the proposed modulation has been introduced, before analyzing its soft-switching area and circulating power mathematically. The final modulation scheme is not difficult to implement, but can help the DAB achieve soft switching, low circulating power, and thereby high efficiency, even with its input or output voltage doubled. These features have been verified by experimental results obtained with a 1.2-kW prototype.

31 May 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YSYanfeng Shen
Yanfeng Shen
Huai WangHuai Wang
Huai Wang
Ahmed Al-DurraAhmed Al-Durra
Ahmed Al-Durra
ZQZian Qin
Zian Qin
Frede BlaabjergFrede Blaabjerg
Frede Blaabjerg
This paper proposes a new bidirectional resonant dc-dc converter suitable for wide voltage gain range applications (e.g., energy storage systems). The proposed converter overcomes the narrow voltage gain range of conventional resonant DC-DC converters, and meanwhile achieves high efficiency throughout the wide range of operation voltage. It is achieved by configuring a full-bridge mode and a half-bridge mode operation during each switching cycle. A fixed-frequency phase-shift control scheme is proposed and the normalized voltage gain can be always from 0.5 to 1, regardless of the load. The transformer root-mean-square (RMS) currents in both the forward and reverse power flow directions have a small variation with respect to the voltage gain, which is beneficial to the conduction losses reduction throughout a wide voltage range. Moreover, the power devices are soft-switched for minimum switching losses. The operation principles and characteristics of the proposed converter are firstly analyzed in this paper. Then the analytical solutions for the voltage gain, soft-switching and RMS currents are derived, which facilitates the parameters design and optimization. Finally, the proposed topology and analysis are verified with experimental results obtained from a 1-kW converter prototype.

21 March 2019 in IEEE Transactions on Power Electronics
Verified
Journal Article
Open access
ZSZhan Shen
Zhan Shen
Huai WangHuai Wang
Huai Wang
YSYanfeng Shen
Yanfeng Shen
ZQZian Qin
Zian Qin
Frede BlaabjergFrede Blaabjerg
Frede Blaabjerg
This paper proposes an improved analytical stray capacitance model for inductors. It considers the capacitances between the winding and the central limb, side limb, and yoke of the core. The latter two account for a significant proportion of the total capacitance with the increase of the core window utilization factor. The potential of the floating core/shield is derived analytically, which enables the model to apply not only for the grounded core/shield, but also for the floating core/shield cases. Based on the improved model, an analytical optimization method for the stray capacitance in inductors is proposed. Moreover, a global Pareto optimization is carried out to identify the trade-offs between the stray capacitance and ac resistance in the winding design. Finally, the analysis and design are verified by finite element method (FEM) simulations and experimental results on a 100 kHz dual active bridge (DAB) converter.